Protocol 7422-5 The Director 105dB Megaphone User manual

  • Hello! I've reviewed the instruction manual for the Megaphone 105 DB. This document details the operation of the device, including how to insert batteries, use the volume control, record and play back speech, and activate the alarm function. I'm ready to answer any questions you have about the megaphone.
  • How do I open the battery compartment?
    What type of batteries does the megaphone use?
    How do I sound the alarm?
    How do I record speech or sound?
    How do I play a recording?
Instruction Manual for
The Director 105 DB Megaphone
Read through this entire instruction manual BEFORE using The
Director 105 DB Megaphone.
Inserting the Batteries:
1. Open the battery compartment by pressing the button located just
below the control panel of the megaphone.
2. Insert 4 ‘D’ batteries according to polarity orientation indicated by (+) and (-) symbols
inside battery compartment.
3. Close battery compartment by gently pressing down until it locks.
4. When sound becomes weak, it is time to change the batteries. Make sure to dispose
of batteries according to manufacturer’s instructions.
Using Your Megaphone:
1. Pull megaphone handle to full, locked extension.
2. Slide volume control to lowest volume (left).
3. Press ON/OFF button to ON position.
4. Slide volume control slightly to the right to increase amplification; slide to the left to
decrease amplification.
5. Speak directly into slots in control panel with mouth as close as possible to unit.
6. Sound alarm by pressing ALARM button (second from left) on control panel. Control
volume of alarm by sliding volume control left (quieter) or right (louder). Press ALARM
button or OFF button to stop alarm.
7. Record speech or sound by pressing RECORD button (third from left). Press
RECORD button again to release it and discontinue recording or press OFF button.
8. Play voice or sound recording by pressing PLAY button (fourth button from left). Press
PLAY button again to stop playing or press OFF button.
/