Numeric keypad
Green LED: Solid = System is Unset.
Red LED: Solid = System is in Alarm.
Blue LED: Solid = Full Set, Flashing = Part Set or some Areas Set
Amber LED: Flashing = System Fault, the ‘0’ key and ‘#’ key will also
flash to indicate to go to the GSD panel to view the fault.
Open Zone: The ‘*’ key will flash to indicate there is an open zone
on the system. Open zones can be viewed on the panel.
Installer Mode: All backlight keys flash to indicate the Installer menu
is active.
LED indicator
3
Status Indicators:
Arming Station operation
Solid when
system is
Full Set
Solid,
system is
Unset
Flashing,
system is
PartSet A
Solid,
system is
in alarm
FullSet:
Note: The system will automatically count down to a FullSet if key 1,2,3 is
not selected.
Unsetting:
PartSet A:
PartSet B:
Panic Alarm:
User Code
or
GSD Fob
System sounds exit
tones and
starts Full Set
+Key 1
User Code
or
GSD Fob
System starts
to
Unset
User Code
or
GSD Fob
System starts
to
PartSet
+Key 2
Flashing,
system is
PartSet B
User Code
or
GSD Fob
System starts
to
PartSet
+Key 3
+
*
Key #
Key System sounds
alarm
Arming Station features
2 Operation Instructions Operation Instructions
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Vanderbilt SPC5320.320 Installation & Configuration Manual
-
Pyronix Paragon Plus User Instructions
-
-
-
Interlogix ATS4500A-IP-LM User manual
-
-
Risco GARDTEC 350+ Installation Instructions Manual
-
-
-
Menvier Security TS700 Operating instructions