2. Toro
  3. 42in Bagging Enhancement Kit, TimeCutter Riding Mower

Toro 42in Bagging Enhancement Kit, TimeCutter Riding Mower Installation guide

  • Hello! I've reviewed the installation instructions for the 42in Bagging Enhancement Kit for the TimeCutter 161-4521 Riding Mower. This document provides detailed steps for preparing both gas and electric models and how to mount the skirt and plate. I'm ready to answer any questions you have about the installation process or the kit itself.
  • What should I do before starting the installation on a gas model?
    What should I do before starting the installation on an electric model?
    What should be used to support the machine?
Form No. 3465-266 Rev A
42in Bagging Enhancement Kit
T imeCutter
®
Riding Mower
Model No. 161-4521
Installation Instructions
Determine the left and right sides of the machine from the normal operating position.
Preparing the Machine
Gas Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
PARK position.
4. Shut of f the machine and remove the key .
5. W ait for all moving parts to stop.
6. Allow machine components to cool.
7. Disconnect the spark-plug.
8. For easier access, raise the front of the machine
and support it using jackstands rated for your
machine.
W ARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury .
Use jack stands when supporting the
machine.
Electric Models Only
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
NEUTRAL position.
4. Engage the parking brake.
5. Shut of f the machine and remove the key .
6. W ait for all moving parts to stop.
7. Allow machine components to cool.
8. Remove the battery packs from the machine.
9. For easier access, raise the front of the machine
and support it using jackstands rated for your
machine.
W ARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury .
Use jack stands when supporting the
machine.
© 2023—The T oro® Company
81 1 1 L yndale A venue South
Bloomington, MN 55420 Register at www .T oro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3465-266*
Installing the Kit
Install the skirt and plate to the mower deck using 5 bolts (5/16 x 1 inch) and 5 nuts (5/16 inch).
g307610
1. Nut (5/16 inch) 2. Skirt
3. Plate
4. Bolt (5/16 x 1 inch)
2
/