Diagram
Safety
Don’ts
Pedal
Lock button
Adjustable height : after quick release, adjust the upper support frame to the suitable gear.
Charging socket
Power switch
Mudapron
Support rod
Tyre
Motor
Seat cushion
Specifications
Retractable kickstand
Put Together the Scooter
① The upper support frame ② Charger ③ Vehicle body ④ The lower support frame ⑤ Seat cushion
Do not remain on the standing
board after shutdown
Important Note:
Attention:
There are risks of riding or driving any vehicle. S6 is no exception. Please make sure this manual is
read through and fully understood before initial use. And be cautious when riding.
1. Sharp acceleration or deceleration or speeding via overly leaning forward or backward are strictly
forbidden.
2. Do not care about the vehicle if there is an emergency. Safety goes first.
Do wear helmet, gloves, elbow/knee pads or other necessary protection gears.
Do not ride S6 on rough or bumpy surfaces, such as muddy or gravel roads.
Do not ride S6 on wet, slippery surafces, especially icy ones.
Do not ride S6 on slopes of over 15°gradient.
Do not allow children under 15 or the aged above 60 to ride S6.
Drunk or drug riding S6 is prohibited.
Do not ride S6 in extremely cold winter.
Do not ride S6 in the rain.
Do keep slow speed when riding S6 on slopes.
Do not ride S6 in other unadvised situations caused by either personal or objective reasons.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Airwheel OPERATING GUIDE
1 pcs
1 pcs
1 pcs
Vehicle body
Seat cushion
Upper support frame
1 pcs
1 unit
1 unit
2 pcs
Lower support frame
Charger
Other accessories
Remote controls
Packing Details
Parameters
Remark
Weight
Standard Accessory
Speed
Max. Climbing Angle
Riders weighing 60kg get up to 18°
Battery Capacity
Working Temperature
Best at 20~30°C
Max. Load
Charge Voltage
Optional:110V/110V-240V
Charge Time
Size
Wheel Size
Bottom Case To Ground
C ~ 40
°
C
14kg
17km/h
~ 15°
130Wh / 260Wh
-10
°
100kg
AC220V 50~60Hz
130Wh: ~ 90min 260Wh: ~ 180min
Height :790mm, Length : 503mm, Width : 322mm
8 inches
53mm
Specifications
Entrance Height
Bumpy Terrains
Slope Angle 15°Slope Angle 15°
Staircases
You need lots of practice to grasp the skill before you ride the scooter safely. If you are not skilled,
or fail to follow the user guide of this product, it may cause rider or the third part physical injury or
property loss. Our company only takes the responsibility for product defects or damage, and we are
NOT responsible for physical injury or property loss related with using products.
①
③
⑤
④
Instruction book
1 pcs
1. 2. 3.
①
⑥
⑦
⑧
⑨
10
⑥ Nut
⑨ Round cover
⑩ Male plug wire
⑦ Quick release
⑧ Sealed cover
4. 5. 6.
11
Screw
④
12
13
Female plug
Male plug
Lock button
13
12
14
14
Put the seat cushion flat, fasten
the upper support frame with
seat cushion in the arrow
direction and then tighten it
with four nuts.
Open the round cover in the
front of the scooter body, let
the male plug wire get through
the lower support frame, with
the three holes on the support
frame to the direction of the
power switch.
Fasten the scooter body and
lower support frame with four
flat gasket nuts and then
install the sealed cover.
Install the female plug in the
upper support frame that is
aligned with the male plug in
the lower support frame in
arrow direction
Ensure the quick release is
open, press the lock button
down and the upper support
frame down to the lower
support frame.
When adjusting the height, the
upper support frame can be
pulled up or down as the locking
button is pressed, and then
make it fixed and tightened.
Arrow
11