Allied Brass MA-21/24-SBR Installation guide

18,24,30,36

0.72

Mounting Hole

PERSPECTIVE

Mounting Bracket

Mounting Screw

Set Screw

MA-21 UNIT

Step 1:

Determine your desired location for installation and make a mark for the location of the mounting bracket. Make 4 marks

where mounting screws will be placed as shown below. Make sure unit is level when marking for location of installation.

Drill hole at each end of the marks.

Drill holes in Wall for Mounting Screw

Attach unit to mounting Surface

Step 2:

Screw down mounting bracket to wall. Then Insert unit to mounting brackets and then lock unit by set screw.

MA-21

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.