dallmeier VMC Installation And Configuration Manual
- Category
- Security camera accessories
- Type
- Installation And Configuration Manual
English
Rev. 1.0.0 / 2010-07-20
Installation and Configuration
PTZ Control
VMC Joystick
VMC Joystick
www.dallmeier.com 2
Information about Copyright, Trademarks, Design Patents
© 2010 Dallmeier electronic
The reproduction, distribution and utilization of this document as well as the communication of
its contents to others without express authorization is prohibited. Offenders will be held liable for
the payment of damages. All rights reserved in the event of the grant of a patent, utility model or
design.
We reserve the right to make technical modications.
The manufacturer accepts no liability for damage to property or pecuniary damages arising due
to minor defects of the product or documentation, e.g. print or spelling errors, and for those not
caused by intention or gross negligence of the manufacturer.
Dallmeier electronic GmbH & Co.KG
Cranachweg 1
93051 Regensburg, Germany
www.dallmeier.com
info@dallmeier.com
All trademarks identied by ® are registered trademarks of Dallmeier electronic.
All trademarks identied by *) are trademarks or registered trademarks of the following owners:
Third-party trademarks are named for information purposes only.
Dallmeier electronic respects the intellectual property of third parties and always attempts to ensure the complete identication of third-party
trademarks and indication of the respective holder of rights. In case that protected rights are not indicated separately, this circumstance is
no reason to assume that the respective trademark is unprotected.
VMC Joystick
www.dallmeier.com 3
Table of Contents
1 Introduction ...................................................................................................4
1.1 Validity .............................................................................................................4
1.2 Documents ......................................................................................................4
1.3 Conventions ....................................................................................................4
2 Safety Instructions........................................................................................6
3 General Notes................................................................................................8
3.1 Scope of Delivery ............................................................................................8
3.2 Transportation and Packaging ........................................................................8
3.3 Appropriate Use ..............................................................................................8
3.4 Performance Features ....................................................................................8
3.5 Warranty .........................................................................................................9
3.6 Certications ...................................................................................................9
4 View and Connection ..................................................................................10
4.1 View ..............................................................................................................10
4.2 Connection ....................................................................................................10
5 Commissioning ...........................................................................................11
6 Key Assignment ..........................................................................................12
7 Conguration ..............................................................................................13
8 Technical Data .............................................................................................15
9 Technical Drawings ....................................................................................16
VMC Joystick
www.dallmeier.com 4
1 Introduction
1.1 Validity
This document applies to the VMC Joystick.
It has been created based on the following versions:
• Dallmeier VMC Setup 1.2.2.0
• PView 77.0.2.9
1.2 Documents
Commissioning
The document entitled “Commissioning” contains the most important steps for the connec-
tion and commissioning of the device.
The target audience is trained and authorized professionals (installers).
Installation and Conguration (this document)
The document entitled “Installation and Conguration” contains detailed descriptions of
the installation, connection, commissioning and conguration of the device. Safety instruc-
tions, general notes and technical data are additionally provided.
The target audience is trained and authorized professionals (installers).
1.3 Conventions
This document contains various warning words and symbols that indicate potential sources
of danger.
DANGER
DANGER indicates a hazardous situation which, if not avoided, will result
in death or serious injury.
WARNING
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
NOTICE indicates practices for preventing property damage, incorrect
congurations or faulty operations.
VMC Joystick
www.dallmeier.com 5
Instructions are indicated by arrows ().
Expressions in bold/italics generally indicate a control element on the device (switches or
labels) or on its user interface (buttons, menu entries).
Paragraphs in italics provide information on basic principles, special features and efcient
procedure as well as general recommendations.
VMC Joystick
www.dallmeier.com 6
2 Safety Instructions
Only use this unit if it is technically in proper working order, to the intended purpose and
while keeping safety and potential dangers in mind.
Qualied personnel
Installation, mounting, connection, commissioning and conguration of the unit may only
be carried out by qualied personnel. This also applies to the maintenance, testing and re-
pair, whereat the regulations of the DIN VDE 0701 series of standards (repair, modication
and inspection of electrical appliances) must be followed.
Regulations
The use of video and audio surveillance systems in general is strictly regulated. Inform
yourself about the applicable laws and regulations regarding data, working and environ-
mental protection before using the unit and ensure compliance with them.
System components
Only use internal components that have been tested and approved by Dallmeier. Inappro-
priate internal components can cause malfunctions, damages and data loss and can result
in loss of warranty.
Modications
Do not make any modications to the hardware or software that has not been tested and
approved by Dallmeier. Inappropriate modications can cause malfunctions, damages and
data loss and can result in loss of warranty.
Documentation
Carefully and completely read the documents included in delivery. Always observe the
contained instructions, notes and warnings.
Condensation water
If the unit is brought from a cold to a warm environment, resulting condensation water
can cause malfunctions and damages. In this case wait (up to 8 hours) until the unit has
reached room temperature before commissioning.
Operating conditions
Unfavourable operating conditions can shorten the life of the unit and can cause malfunc-
tions, damages and data loss and can result in loss of warranty. Observe the specications
given in the technical data, the operating condition requirements and the maintenance
instructions.
Shocks
Shocks can cause malfunctions and damages. The unit may not be moved while in ope-
ration.
Foreign bodies
If objects or liquids get into the unit, immediately disconnect it from the power supply (pull
out the power plug). Contact the sales partner responsible for your area.
VMC Joystick
www.dallmeier.com 7
Burnt smell
If you notice burnt smell or formation of smoke from the unit, immediately disconnect it from
the power supply (pull out the power plug). Contact the sales partner responsible for your
area.
Opening
The housing of the unit may only be opened by qualied personnel for commissioning,
inspection, maintenance and repair.
Disposal
Disconnect the unit from the power supply. Remove all connected devices. Return the unit
to your respective sales partner.
VMC Joystick
www.dallmeier.com 8
3 General Notes
3.1 Scope of Delivery
Included in the standard scope of delivery is:
1× VMC Joystick
1× USB cable 200 cm
1× Documentation Installation and Conguration (CD)
1× Documentation Commissioning (in print)
The scope of delivery may differ depending on the ordered equipment, the device variant
or the country of destination.
The functional range of the device depends on the ordered equipment or device variant
and may differ from this document’s content. Certain functions and features may require an
activation that is subject to costs.
3.2 Transportation and Packaging
Store the original packaging for transportation at a later date. Dallmeier electronic is not
responsible for damage resulting from unprofessional/improper transportation. The goods
should only be shipped in their original packaging.
If the original packaging is no longer available, ensure that the packaging used sufciently
protects the unit against damage, moisture, heat and cold.
3.3 Appropriate Use
The VMC Joystick enables the remote control and display of up to 24 cameras via Dallmei-
er PView station PVS 7.
The joystick´s ergonomic design and compact construction form allows a user-friendly and
efcient operation even in the most conned space.
3.4 Performance Features
The VMC Joystick is especially characterised by the following functions and properties:
• Remote ccontrol of the speed, pan/tilt, focus, zoom and iris function of the PTZ dome
cameras
• Control interfaces: USB
• Control via PView station PVS 7
• 2,4 up to 57,6 kbps Baud rate
• Supported control protocols: DCCP, Pelco D, Pelco P
• Control of up to 24 PTZ dome cameras
• User-friendly tri-axial joystick
• DIN EN 50130-4 certied
VMC Joystick
www.dallmeier.com 9
3.5 Warranty
The terms and conditions valid at the signing of the contract shall apply.
3.6 Certications
Following approvals/certications were valid at the time of document compilation.
• CE
• DIN EN 50130-4 compliant
VMC Joystick
www.dallmeier.com 10
4 View and Connection
4.1 View
Fig. 4-1
A Joystick modul
B Joystick
4.2 Connection
C
E
Fig. 4-2
Open the cable interlock (C).
Connect the USB cable to the USB socket (D).
Insert the USB cable into the cable conduit (E).
Close the cable interlock (C).
The VMC Joystick is ready for commissioning.
BA
D
VMC Joystick
www.dallmeier.com 11
5 Commissioning
In order to take the VMC Joystick into operation proceed as follows.
Connect the VMC Joystick to the PC / workstation (hot-plug).
The operating system detects the new device automatically.
Note the messages from the operating system.
Follow the instructions given by the operating system.
Finish the installation of the USB driver.
The VMC Joystick is ready for operation with PView 7.
Note the corresponding PView 7 documentation.
The VMC Joystick should be calibrated after the installation of the USB driver. The appro-
priate operating system dialog can be opened in the system control.
Windows XP
Open Start > Control Panel > Gamecontroller > Hydra Joystick.
Windows 7
Open Start > Devices and Printers > Hydra Joystick.
VMC Joystick
www.dallmeier.com 12
6 Key Assignment
A
B
C
D
E F
G
H
I
J
L
K
Fig. 6-1
A Zoom Out
B Zoom In
C Close apperture
D Previous split
E Next split
F Previous camera
G Next camera
H Open apperture
I Focus +
J Focus –
K Joystick
L Joystick-Taste
Pan a PTZ camera (PAN)
Move the joystick left or right.
Tilt a PTZ camera (Tilt)
Move the joystick up or down.
Zoom a PTZ camera on or off
Turn the joystick left or right to the live image.
VMC Joystick
www.dallmeier.com 13
7 Conguration
The VMC Joystick keyboard layout can be congured individually with PView 7 functions.
This is done by the assignment of the corresponding hotkey combination.
Start PView 7.
Open the Conguration dialogue via Program > Conguration.
Select the HotKeys tab.
Fig. 7-1
Select the relevant Category.
Select the relevant Command.
Press the designated VMC Joystick key.
The VMC Joystick key is displayed in the New hotkey eld.
Conrm with Accept.
Proceed analogous for all relevant keys.
Finally conrm with OK.
VMC Joystick
www.dallmeier.com 14
The following table shows the standard key assignment for a connected VMC Joystick.
Category Command Key combination Key
Main panel Next camera Joystick button 3 G
Main panel Toggle digital zoom –
motor zoom
Joystick button 12 L
Main panel Previous camera Joystick button 2 F
Camera control Open aperture Joystick button 7 H
Camera control Close aperture Joystick button 6 C
Camera control Focus in Joystick button 8 I
Camera control Focus out Joystick button 9 J
Camera control Zoom in Joystick button 5 B
Camera control Zoom out Joystick button 4 A
Split Next Split Joystick button 1 E
Split Previous Split Joystick button 0 D
VMC Joystick
www.dallmeier.com 15
8 Technical Data
Following technical data was valid at the time of document compilation.
Refer to www.dallmeier.com for possible updates.
Type 3 axes with button
Control Protocol DCCP, Pelco D, Pelco P
Baud-Rate 2,4 up to 57,6 kbps
Interface USB 2.0, Type B
Mains voltage 5 V DC (via USB)
Power consumption Max. 2,5 W
Temperature + 5° C to + 35° C
Humidity 10 – 70 % RH, non-condensing
Dimensions Ca. 138 mm x 128 mm x 224 mm
Weight Ca. 900 g
Certicate CE, DIN EN 50130-4
VMC Joystick
www.dallmeier.com 16
9 Technical Drawings
Top View
Fig. 9-1
Front View
Fig. 9-2
Unit: mm
138
224
128
Declaration of Conformity
This declaration is valid for following product:
Equipment: Camera control device
Type: VMC
Hereby the equipment is conrmed to comply with the requirements set out in the Council
Directive on the Approximation of the Laws of the Member States relating to Electromagnetic
Compatibility (2004/108/EC).
The following company is responsible for this declaration:
Dallmeier electronic GmbH & Co.KG
Cranachweg 1
D 93051 Regensburg
The measurements were carried out in accredited laboratories.
For the evaluation of above mentioned Council Directives for Electromagnetic Compatibility
and for Low Voltage following standards were consulted:
DIN EN 55022: 2001-04 class B
DIN EN 50130-4: 2003-10
DIN EN 61000-4-2: 2001-12
DIN EN 61000-4-3: 2003-11
DIN EN 61000-4-4: 2002-07
DIN EN 61000-4-5: 2001-12
DIN EN 61000-4-6: 2001-12
DIN EN 61000-4-8: 2001-12
DIN EN 61000-4-11: 2001-12
DIN EN 61000-3-2: 2001-12
DIN EN 61000-3-3: 2002-05
Regensburg, 20-0- Dieter Dallmeier
-CEO-
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
dallmeier VMC Installation And Configuration Manual
- Category
- Security camera accessories
- Type
- Installation And Configuration Manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI