LogiLink wl0143 Quick User Manual

Brand: LogiLink

Model: wl0143

Category: Routers

Type: Quick User Manual

LogiLink wl0143 is a dual-band concurrent Gigabit AP router with 300/450Mbps PHY data rate. It supports Wi-Fi ON/OFF and WPS switch buttons, 20/40 MHz channel bandwidth, long and short preamble modes, and various security protocols. With Multi-SSID, IEEE 802.11e QoS enhancement, SPQ/WRR QoS, and VLAN support, it offers flexible network configurations. The device features hardware NAT, remote firmware updates, and webpage configuration support.

Size: 84 x 118.4mm

* 100P

* , (),

()

* ,

- 1 -

According to the European WEEE directive, electrical and

electronic equipment must not be disposed with consumers waste.

Its components must be recycled or disposed apart from each other.

Otherwise contaminative and hazardous substances can pollute

our environment.

You as a consumer are committed by law to dispose electrical and electronic

devices to the producer, the dealer, or public collecting points at the end of the

devices lifetime for free. Particulars are regulated in national right. The symbol

on the product, in the user's manual, or at the packaging alludes to these

terms. With this kind of waste separation, application, and waste disposal of

used devices you achieve an important share to environmental protection.

1.0 Safety Instruction

Put the Device always on a stable and straight Surface. In case

of falling it can be damaged.

Don’t place the Device into direct Sunlight or in Places with high

Temperature. This can damage the Device or shorten his

average useful Life.

Don’t place it in the near of Heat Sources, like Radiators or other

heat producing Devices.

Don’t expose the Device to Rain, Water, Wetness or high Humidity.

Don’t place it in the Bathroom or the Kitchen in the near of a Sink.

Avoid the direct Contact with Water.

Don’t try to open the Device.

Prior to the first use of our product make a backup of your data.

We are not liable for any loss of data, unless you can accuse us

intention or gross negligence.

In any case, liability for loss of data is limited to the effort that is

necessary to restore from existing backup copies.

Congratulations to the Purchase of WL0143!

Please read the Manual and Safety Instructions before using the

product for the first time. Otherwise damage can be the result.

- 2 -

2.0 Introduction

2.1 Specification

 3T3R 2.4 / 5GHz dual band concurrent with 300/450Mbps PHY

data rate

 Compliant with IEEE 802.11a/n/g/b standards

 Supports Wi-Fi ON/OFF switch button

 Supports Wi-Fi WPS switch button

 20/40 MHz channel bandwidth

 Supports long and short preamble modes

 Compliant with transmit modulation accuracy and transmit

power spectral density

 IEEE 802.11i . Security: WEP 64/WEP

28/TKIP/AES/WPA/WPA2/MAC/IP Address Filter

 Supports Multi-SSID

 IEEE 802.11e QoS enhancement (WMM)

 Supports SPQ/WRR QoS

 Ethernet port supports ingress and egress rate limiting

 Supports VLAN and Dual Images

 MAC clone and Broadcast storming

 Hardware NAT (Bi-direction LAN to LAN throughput 475Mbps)

 APS remote firmware updates function through FTP server

 Webpage configuration support levels (Admin and user)

2.2 Package Contents

 1 x Wireless Dual-Band Concurrent Gigabit AP Router

 1 x Ethernet Cable (RJ-45)

 1 x Power Adapter

 3 x Detachable Antennas

 1 x CD (Driver + Manual)

 1 x Quick Installation Guide

- 3 -

3.0 Installation & Setup

Follow each STEP carefully and only go to the next step once you

have completed the previous STEP.

 STEP 1

Connection of WL0143

LED Meaning

The WL0143 has indicator lights on the front side. Please see

below for an explanation of the function of each indicator light.

Power indicator WPS Active indicator

WAN Active indicator

Ethernet Active indicator

Wireless Active indicator

- 4 -

LED Function

LED Color On Flash Off

Green Ready

Waiting for

device ready

Power Off

Green WLAN Ready

Transmit /

Receive Data

WLAN Off

Green N/A

Start WPS

pairing within

2 minutes

WPS Idle

Green

10/100MB Ethernet

Ethernet connection

established and

active

Transmit /

Receive Data

Ethernet

Disconnected

Amber

1000MB Ethernet

Ethernet connection

established and

active

Transmit /

Receive Data

Ethernet

Disconnected

The icons appear on the products are for application indication

only.

The trademark or intellectual property is belonging to their

respective owners.

Rear View of the WL0143

Note: Actual ANTENNA may vary depending on model.

- 5 -

WPS and WLAN button

Note: WPS button is for 5G wireless only.

Please press WPS button 0.5 seconds at least to active

WPS pairing.

 STEP 2

Configuration Procedures

Before starting The WL0143 configuration, please kindly

configure the PC computer as below, to have automatic IP

address / DNS Server.

For Windows 98SE/ME/2000/XP

Click on "Start" -> "Control Panel" (in Classic View). In the Control

Panel, double click on "Network Connections" to continue.

- 6 -

Single RIGHT click

on "Local Area

connection", then

click "Properties".

Double click on "Internet

Protocol (TCP/IP)".

Check "Obtain an IP address

automatically" and "Obtain

DNS server address

automatically" then click on

"OK" to continue.

Click "Show icon in notification

area when connected" (see

screen image in 3. above) then

Click on "OK" to complete the

setup procedures.

- 7 -

For Windows 7-32/64

Click on "Start" ->

"Control Panel" (in

Category View) ->

"View network status

and tasks".

In the Control Panel

Home, click on

"Change adapter

settings" to continue.

Single RIGHT click on "Local Area connection", then click

"Properties".

- 8 -

Double click on "Internet

Protocol Version 4 (TCP/IPv4)".

Check "Obtain an IP address

automatically" and "Obtain DNS

server address automatically"

then click on "OK" to continue.

 STEP 3

WL0143 Configuration

Please insert the supplied CD into your CD-ROM drive.

The CD should auto-start, displaying the window shown in 3.

below. If your CD does not start automatically, go to Windows

Explorer, Select your CD drive and double click autorun.exe.

- 9 -

To configure the device, please click on “Advanced

Configuration” button.

Please enter the User Name:

admin and Password: 1234 and

then click on OK button.

From the Internet Settings menu, click on WAN.

- 10 -

Select the WAN Connection Type STATIC (fixed IP), DHCP (Auto

config) or PPPoE (ADSL) and enter related parameters that your

ISP (Internet Services Provider) or Network Administrator

provided and then click on Apply button.

 STEP 4

Connect Wirelessly

For easy installation it is saved to keep the settings. You can later

change the wireless settings via the wireless configuration menu.

(see user manual on the CD)

Double click on the wireless icon on your computer and search

for the wireless network that you enter Network Name(SSID)

name. (the default settings Radio On/Off = On, Network

Name(SSID) = WL0143_5G for 5G or WL0143_2.4G for 2.4G)

- 11 -

Click on the wireless network that you enter SSID name to

connect.

If the wireless network isn’t encrypted, click on Connect Anyway

button to connect.

If the wireless network is encrypted, enter the network key that

belongs to your Encryption type and Passphrase (the default

settings Security Mode = Disable). You can later change this

network key via the wireless configuration menu.

- 12 -

Click on Connect or Apply button.

Now, The WL0143 has been configured, and able to connect to

ISP/ Website.

For more detail, please refer to the detail manual in the CD.

CE Declaration:

This device corresponds to EU directive 1999/5/EC and

2006/95/EC: With the CE sign Logilink®, a registered

trademark of the 2direct GmbH ensures, that the product is

conformed to the basic standards and directives. These standards

can be requested online on www.logilink.com. All trademarks and

registered brands are the property of their respective owners.

LogiLink wl0143 Quick User Manual

Brand: LogiLink

Model: wl0143

Category: Routers

Type: Quick User Manual

Download PDF

report

LogiLink wl0143 Quick User Manual

LogiLink wl0143 Quick User Manual

Related papers

Other documents