- 1 -
KSOL-2 UNIVERSAL CONSTRUCION WITH MULTIPLE KS2000
COLLECTORS ASSEMBLY INSTRUCTION.
Spacing of openings for the assembly of the KSOL-2 universal structure
vb
f
No Name Mount
1 Vertical bar 2
2 Upper horizontal bar 1
3 Lower horizontal bar 1
4 Bottom connector 2
5 Back connector 2
6 Diagonal connector 1
7 Base 4
8 Collector grasper 6
9 Connector 4
10 Connector 4
11
Insert
10
12 Screw M6x40 8
13 Nut M6 8
14 Screw M8x16 24
15 Screw M8x20 4
16 Washer Ø8 28
17 Nut M8 28
18 Nut cap 12
18
11
10
9
1
a
1
b
1
c
2a
2b
2c
2d
3
4
- 2 -
The KSOL-2 universal structure is used to mount a set of 2 KS2000 collectors.
Steps of the assembly:
1. Attach the connectors (10) to the horizontal bars (2, 3). Attach the top horizontal bar (the one with less rubber washers) (2), and the
bottom one (3) to the vertical bars (1).
2. Attach the bases (7), the bottom connector (4), the back connector (5) and the diagonal connector (6).
3. During the assembly, remove the upper collector graspers (8). Place the solar collectors on the frame’s platform, keeping a distance
of 85 mm between the collectors. Put the top graspers (8) in the place marked with rubber washers and put caps on the nuts (18).
4. Push in and screw tight the bottom graspers of the collector (8) and put caps on the nuts (18).
/
