Livoo DOM407AC1 User manual

Brand: Livoo

Model: DOM407AC1

Type: User manual

Instruction Manual

WWW.LIVOO.FR

Reference: DOM407AC1

Version: 1.4

Language: English

Air purifier filter

Instruction Manual

You have purchased a LIVOO brand product and we thank you for it. We give great attention to the design,

ergonomics and ease of use of our products. We hope that this product will give you complete satisfaction.

This instruction manual is available too on our website www.livoo.fr

CLEANING AND MAINTENANCE

To keep your air purifier functioning properly, we recommend changing the HEPA filter and active carbon

pre-filter after approximately 6 months of usage. More frequent changing will be necessary if the product

is used in an area with a high level of airborne contaminants (such as excessive amounts of smoke, pet

dander, etc.). Exposing the product to candle /oil/fireplace and smoke is not recommended and will

require more frequent maintenance.

Note: ALWAYS MAKRE SURE THE AIR PURIFIER IS TURNED OFF AND UNPLUGGED BEFORE CHANGING

FILTER OR CLEANING.

DO NOT use water or any household cleaners or detergents to clean the HEPA filter.

The inlet grill may be cleaned (after the unit is turned off and unplugged) with a vacuum or a slightly damp

cloth.

Changing the HEPA filter

1. Release the inlet grill by pressing on the locking latch on the back of the appliance

2. Remove inlet grill from the unit as shown below.

3. Grab the frame on both sides of the HEPA filter and remove the filter from the product.

4. Insert the new HEPA filter. Make sure it is facing correct direction.

5. Reattached the inlet grill and secure the locking latch into place.

Press and hold the timer and auto buttons at the same time for 3 seconds to reset the filter

changing Indicator.

Changing the Pre-filter

1. Release the inlet grill by pressing on the locking latch on the back of the appliance.

2. Remove the inlet grill from the unit.

3. Grasp the pre-filter from the backside of the inlet grill and remove the pre-filter.

4. Insert new pre-filter into the inlet grill.

5. Reattach the inlet grill and secure the locking latch into place.

6. Press and hold the timer and auto buttons at the same time for 3 seconds to reset the filter

changing indicator.

Instruction Manual

Attention：

 Please carefully identify the front and rear direction of the filter assembly to avoid wrong

installation.

 It is recommended to wear gloves when replacing the filter. And in order to prevent the

secondary pollution in the old filter components, please put the old filter components in plastic

bags before discarding them to prevent the secondary pollution to the environment.

Correct disposal of the unit

(Electrical and Electronic Equipment)

(Applicable in the European Union and the rest of Europe that have adopted separate collection systems

countries)

The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old

household electrical appliances must not be disposed of in the normal household waste stream.

Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain and

reduce the impact on human health and the environment.

The symbol of the crossed out dustbin is marked on all products to remind the obligations of separate collection.

Consumers should contact their local authority or retailer for information concerning the correct disposal of their product.

• Photo no contractual

• Worried about the quality of his products the manufacturer reserves the right to make modifications without advance

Livoo DOM407AC1 User manual

Livoo DOM407AC1 User manual

Livoo DOM407AC1 User manual

Related papers

Other documents