KJ15041123

Kamado Joe KJ15041123, KJ15041123 Wire Harness 18 Inch Red Digital Charcoal Grill and Smoker Installation guide

Hello! I've reviewed the user manual for the Konnected Joe Wire Harness. This document provides detailed instructions on how to safely replace the wire harness, including important safety precautions and step-by-step guides. I am here to help you with any questions about the replacement process or any other details from the document.
What should I do before handling the grill?

Are there any sharp edges to be concerned about?

What should I be careful of when disconnecting the wire harness?

Instruction Sheet Code: 9804220058 221115-GH

Konnected Joe™

Wire Harness

KJ15041123/KJ15041523

CAUTION - SAFETY PRECAUTIONS - READ BEFORE USE

• Make sure your grill has fully cooled before handling to avoid burns.

• Some components may have sharp edges. Use caution to avoid injury.

• Disconnect the power supply from the grill before handling.

Remove two screws from front module. Remove front module.

Unplug lid switch, pit probe, and power supply.

Disconnect the wire harness from the front

module. Use caution do not apply tension

on the wire harness.

5-PIN

6-PIN

4-PIN

Remove the three wire harness cover screws. Remove the wire harness cover.

Disconnect the wire harness from the rear

module. Use caution do not apply tension on

the wire harness. (Note - leave the element

wires connected).

Fish the new wire harness through the front

pass through hole. Fish the new wire harness through the rear

pass through hole.

Repeat the steps in reverse order to install the new wire harness.

5-PIN

6-PIN

4-PIN

Loosen two screws from rear module.

Please note, the screws do not have to be fully

removed to disengage the rear module.

/

Other documents