SEYMOUR Z-604 Owner's manual

Z-604 TRAFFIC MARKING MACHINE

Designed exclusively for Stripe traffic marking paints, this easy

to use machine applies crisp stripes to concrete or pavement.

Use on parking lots, warehouses, running tracks, and

playgrounds. Holds up to 12 cans for large jobs.

Directions:

1. Turn can upside down and place into the holder of the Z-604.

The long sides of the sprayhead must be parallel to the axle.

2. Establish your line width. By loosening the wingnuts on

both sides of the machine, you can adjust the can platform up

or down. Stripes approximately 2 to 4 inches wide can be

applied.

3. Squeeze trigger to activate spray. To avoid any possible

“build-up” of paint when starting, it is suggested that the

machine be in motion when passing over the starting point.

Replacement Parts:

#3026 Can Holder Assembly #3027 Spring Clip Kit #3031 Trigger Assembly

#3038 Spare Fasteners Kit #3040 7 inch wheel #3043 Handle and Cable

#3034 Axle #3040 Handle Grip #3043 Handle Support Brace

This manual is also suitable for