Page is loading ...
GW003100AJ Wheel-Handle Assembly Instructions
Parts Included: 1 axle, 2 wheels, 1 handle, 1
GW003150AJ Parts pack.
Foot installation:
1. Position the engine end of the unit for
access to holes in bottom of the frame.
Caution: use safe lifting technique. Be
certain the unit is stable and adequately
supported. Note: to avoid fuel spillage, do
not tilt the unit more than 30 degrees.
2. Install self-tapping hex-washer head screw
through foot and into hole in bottom of the
frame tube (3/8 wrench). Tighten screw one
full turn past point where foot is held to the
tube by the screw (repeat process for foot
on opposite side).
Wheel/Axle installation:
1. Lift the generator end of the unit to allow
clearance for wheel installation. Be certain
the unit is stable and adequately supported.
Note: to avoid fuel spillage, do not tilt the
unit more than 30 degrees.
2. Install axle through holes in unit frame;
approximately 3 inches of axle should
protrude from each side of the frame.
3. Install the following items on each end of
the axle in the order listed: thin metal
washer, plastic spacer, wheel, thin metal
washer, and cotter pin in the hole at the end
of the axle. Spread ends of cotter pin to
retain.
1 IN954300AV 03/09
Handle installation:
1. Align the holes in the ends of the
handle with the holes in each of the side
tubes (at the engine end of the unit).
2. Insert the ¼ inch hex bolt through the
hole in the end of the handle and
through the holes in the side tubes.
3. Place a ¼ inch washer and a ¼ inch hex
nut onto the end of the bolt, tighten nut
(7/16 wrenches) until handle is snug
against side tubes of the unit
2 IN954300AV 03/09
/
