Campbell Hausfeld GW003100AJ Owner's manual

Campbell Hausfeld

Brand: Campbell Hausfeld

Model: GW003100AJ

Type: Owner's manual

GW003100AJ Wheel-Handle Assembly Instructions

Parts Included: 1 axle, 2 wheels, 1 handle, 1

GW003150AJ Parts pack.

Foot installation:

1. Position the engine end of the unit for

access to holes in bottom of the frame.

Caution: use safe lifting technique. Be

certain the unit is stable and adequately

supported. Note: to avoid fuel spillage, do

not tilt the unit more than 30 degrees.

2. Install self-tapping hex-washer head screw

through foot and into hole in bottom of the

frame tube (3/8 wrench). Tighten screw one

full turn past point where foot is held to the

tube by the screw (repeat process for foot

on opposite side).

Wheel/Axle installation:

1. Lift the generator end of the unit to allow

clearance for wheel installation. Be certain

the unit is stable and adequately supported.

Note: to avoid fuel spillage, do not tilt the

unit more than 30 degrees.

2. Install axle through holes in unit frame;

approximately 3 inches of axle should

protrude from each side of the frame.

3. Install the following items on each end of

the axle in the order listed: thin metal

washer, plastic spacer, wheel, thin metal

washer, and cotter pin in the hole at the end

of the axle. Spread ends of cotter pin to

retain.

1 IN954300AV 03/09

Handle installation:

1. Align the holes in the ends of the

handle with the holes in each of the side

tubes (at the engine end of the unit).

2. Insert the ¼ inch hex bolt through the

hole in the end of the handle and

through the holes in the side tubes.

3. Place a ¼ inch washer and a ¼ inch hex

nut onto the end of the bolt, tighten nut

(7/16 wrenches) until handle is snug

against side tubes of the unit

2 IN954300AV 03/09

1
2

Campbell Hausfeld GW003100AJ Owner's manual

Campbell Hausfeld

Brand: Campbell Hausfeld

Model: GW003100AJ

Type: Owner's manual

Other documents