Pool Time 23537PTM Installation guide

STEP

BALANCE

Calcium Hardness

Increaser

DIRECTIONS FOR USE:

It is a violation of Federal Law to use this product in any manner inconsistent with its labeling. Read entire

label and use strictly in accordance with precautionary statements, storage, disposal and directions.

DIRECTIONS FOR USE: Read entire label and use strictly in accordance with precautionary statements and

directions. Do not pre-dissolve this treatment as heat is generated when this product contacts water.

Calcium hardness in pool water should be maintained at 175-225 ppm. DO NOT ALLOW calcium hardness to fall

below 100 ppm or damage of pool surfaces and equipment may result.

With a POOL TIME TEST KIT, test for calcium hardness at pool opening, then monthly throughout the season. If

calcium hardness is too low, add this product as follows.

General Application: Broadcast CALCIUM HARDNESS INCREASER in the pool at the rate suggested in the Dosage

Chart below. Use full strength. After treatment, retest. Brush pool to help dissolve products that may settle to the

bottom.

IN CASE OF MEDICAL EMERGENCY, CALL 1-877-800-5553.

NOTE: User assumes all responsibility for use not in accordance with directions.

DOSAGE CHART: CALCIUM HARDNESS INCREASER

pool To Raise Calcium Hardness By:

capacity 50 ppm 60 ppm 80 ppm 100 ppm 150 ppm 200 ppm

10,000 5 lb 6 lb 8 lb 10 lb 15 lb 20 lb

15,000 8 lb 9 lb 12 lb 15 lb 24 lb 30 lb

20,000 10 lb 12 lb 16 lb 20 lb 30 lb 40 lb

30,000 16 lb 18 lb 24 lb 30 lb 45 lb 60 lb

40,000 20 lb 24 lb 32 lb 40 lb 60 lb 80 lb

50,000 25 lb 30 lb 40 lb 50 lb 75 lb 100 lb