Draper Pneumatic Jack, 30 Tonne, has been designed for lifting vehicles up to its maximum weight and height limit and should only be used for lifting purposes. Remember to use axle stands to support the load. This jack has a maximum capacity of 30 tonnes and a minimum height of approximately 150mm. The maximum height, including extensions and capacity, is 409mm at 15 tonnes. The extensions are approximately 45/75mm in size. The chassis length is approximately 430mm, the handle length is approximately 1200mm, and the chassis width is approximately 176mm. The air consumption is approximately 10.
Draper Pneumatic Jack, 30 Tonne, has been designed for lifting vehicles up to its maximum weight and height limit and should only be used for lifting purposes. Remember to use axle stands to support the load. This jack has a maximum capacity of 30 tonnes and a minimum height of approximately 150mm. The maximum height, including extensions and capacity, is 409mm at 15 tonnes. The extensions are approximately 45/75mm in size. The chassis length is approximately 430mm, the handle length is approximately 1200mm, and the chassis width is approximately 176mm. The air consumption is approximately 10.
Draper Pneumatic Jack, 30 Tonne, has been designed for lifting vehicles up to its maximum weight and height limit and should only be used for lifting purposes. Remember to use axle stands to support the load. This jack has a maximum capacity of 30 tonnes and a minimum height of approximately 150mm. The maximum height, including extensions and capacity, is 409mm at 15 tonnes. The extensions are approximately 45/75mm in size. The chassis length is approximately 430mm, the handle length is approximately 1200mm, and the chassis width is approximately 176mm. The air consumption is approximately 10.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI