White Mountain Hearth Rushmore DVCT40CSP Gas Conversion LP to NAT Owner's manual

Brand: White Mountain Hearth

Model: Rushmore DVCT40CSP Gas Conversion LP to NAT

Type: Owner's manual

This manual is also suitable for

Renegade DVCT40CSP Conversion Kit (LP to NAT)

41057-0-0719 Page 1

INSTALLATION INSTRUCTIONS

DIRECT

VENT GAS FIREPLACE

WARNING

This conversion kit must be installed by an Empire Comfort Systems distributor (or other

qualied agency¹)*in accordance with the manufacturer’s instructions and all codes and

requirements of the authority having jurisdiction. Failure to follow instructions could result

in serious injury or property damage. The qualied agency performing this work assumes

responsibility for this conversion.

1National Fuel Gas Code Z223.1 (Latest Edition)

*The term “qualied individual, rm, corporation or company which either in person or through

a representative is engaged in and is responsible for (a) the installation of gas piping or (b)

the connection, installation repair, or servicing of equipment, who is experienced in such

work, familiar with all precautions required, and has complied with all the requirements of the

authority having jurisdiction.

CHECK SAFETY SHUTDOWN PERFORMANCE

WARNING

Perform the safety shutdown test anytime work is done on a gas system to avoid the possibility

of re or explosion with property damage, personal injury or loss of life.

SAFETY SHUTDOWN SYSTEM

Intermittent Pilot System

1. Turn "OFF" using remote control. Main burner and pilot should go off.

2. Pilotgasowshouldstopwithin30seconds.

PARTS LIST

Part Description Conversion Kit Quantity Supplied

MainBurnerOrice,Front P184(#35) 1

MainBurnerOrice,Rear P213(#37) 1

SIT Gas Valve Conversion Kit R11381 1

Gas Conversion Label 1224 1

Target,Front 38042 1

Target,Rear 40647 1

TOOLS NEEDED:

• StandardScrewdriver

• 1/4-Inch Hex Driver

• 5/16-InchHexDriver

• 7/16-InchWrench

• 7/16-InchDeep

Socket Set

Gas input for direct-vent replace converted to Natural Gas: DVCT40CSP95N

Thedirect-ventgasreplacewhenconvertedtoNaturalGaswillhaveamanifoldpressureofapproximately

3.5inchesw.c.(.871kPa)atthevalveoutletwiththeinletpressuretothevalvefromaminimumof4.5inchesw.c.

(1.120kPa)forthepurposeofinputadjustmenttoamaximumof14.0inchesw.c.(3.484kPa).

FOR USE ON: DVCT40CSP95P CONVERSION KIT PART NUMBER 40637

FORCONVERSIONTO NATURAL GAS

41057-0-0719Page 2

INSTRUCTIONS FOR CONVERSION

1. Ifthereplaceisinstalled,turnOFFgasandelectricsupply

toreplacebeforemakinggasconversion.AllowFireplaceto

cool completely.

2. Removebarrierscreen,glassdoor,logsandembers,and

liners. See Homeowner's Manual.

Figure 1

3. Removemiddleandouterburnersbyremovingscrewson

leftandpullingouttowardsleftside.See Figure 2.

Figure 2

4. Remove(2)screwsholdingpilotassemblytoburnerpan.

Thiswillallowpilotassemblytodrop.

5. Remove(4)screwsholdingburnerbaseinplace.

 Liftburnerbaseoutofrebox.See Figure 4.

Figure 4

6. Usea7/16inchdeepsocketsettoremoveorices.

See Figure 5.

FRONT

REAR

Figure 5

7. Locatetheoricemarked"37."Usea7/16inchdeepsocket

settoinstalloricemarked"37"ontorearoriceholder.Use

needle-nosepliers,screwmiddletarget40647ontorear

oriceholder.See Figure 6.

8. Locatetheoricemarked"35."Usea7/16inchdeepsocket

settoinstalloricemarked"35"ontofrontoriceholder.Use

needle-noseplierstoscrewfronttarget38042ontoorice

holder. See Figure 6.

FRONT

REAR

Figure 6

41057-0-0719 Page3

9. Loosenrearairshutterscrewandrotatehandletotheleft

untilfullyclosedisachievedandtightendownscrew.

See Figure 7.

10.Repeatwithfrontuntilfullyclosed.

REAR

FRONT

CLOSED

OPEN

MIDDLE AIR

SHUTTER

SCREW

OUTER AIR

SHUTTER

SCREW

Figure 7

11. Usea7/16inchopenwrenchtoloosenpilotbodybyslightly

turningcounterclockwise.Slideoricebrackettootherside

andtightenpilotbodyclockwise.See Figure 8.

“NAT” MARKING

Figure 8

12. Replaceitemsremovedinsteps2-5inreverseorder.

13. Turngasandelectricon.

14. Gas conversion is completed.

Themainburnerameandpilotburneramemustbechecked

forproperamecharacteristics,asoutlinedintheInstallation

InstructionsandOwner'sManual.

Ifreplaceisnotinstalledorprojectregistrationcardhasnot

beenreturnedtoEmpireComfortSystem’s,checkofftypeof

gasconvertedtoonthecard.Alsoindicateconversionbyadding

“Conv.” behind type of gas.

41057-0-0719Page 4

www.empirecomfort.com

Empire Comfort Systems Inc.

Belleville, IL

If you have a general question

aboutourproducts,pleasee-mail

us at [email protected].

If you have a service or repair

question,pleasecontactyourdealer.

White Mountain Hearth Rushmore DVCT40CSP Gas Conversion LP to NAT Owner's manual

Brand: White Mountain Hearth

Model: Rushmore DVCT40CSP Gas Conversion LP to NAT

Type: Owner's manual

This manual is also suitable for

Renegade DVCT40CSP Conversion Kit (LP to NAT)

Download PDF

report

White Mountain Hearth Rushmore DVCT40CSP Gas Conversion LP to NAT Owner's manual

This manual is also suitable for

White Mountain Hearth Rushmore DVCT40CSP Gas Conversion LP to NAT Owner's manual

Related papers

Other documents