Installation Guide
ON
© VONN Lighting,2019
Model: VOW1336
Parts List
A.
B. Mounting Screw x 3
C.
D.
E.
A
B
C
D
E
Circuit Box
Mounting Plate
Hex Screws x 2
Wire Connectors x 4
Hex Wrench
Make sure that you have all necessary parts by checking the parts list. If
any part is missing or damaged, please contact VONN Lighting
Customer Service at 888-604-8666 for a replacement.
Please read and comprehend the entire manual before attempting to
assemble, operate, or install the product.
VONN highly recommends to use a qualified, licensed electrician to install
the fixture.
LED INFO & WARNINGS
•
•
All parts must be used as indicated in these instructions. Do not substitute
any parts, leave parts out, or use any parts that are worn or broken.
•
Inspect the LED fixture prior to installation to make sure that it has not
been damaged during shipping.
•
Please handle the LED light with care when unpacking. Do not apply
pressure to the LEDʼs, do not open any factory sealed compartments, and
do not touch the LEDs with your hands.
•
Shut “OFF” the electricity at main fuse box.
•
•
Do not remove or replace VONN manufactured parts that are provided
with the fixture.
VONN Lighting
Tools You May Need
GOGGLES
TAPE MEASURE
RUBBER
GLOVES
PHILLIPS
WRENCH
DRILL
SCREW DRIVER
6 5/8”
5 4/5”
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
10 1/8”
(257mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(147.3mm)
(96mm)
1 3/4”
(
45mm)
1 15/16”
(
50mm)
9/16”-18UNEF
27mm ~ 41.3mm
1 1/16” ~ 1 5/8”
1 15/16”
(
50mm)
12 7/16”
(316mm)
1 5/8”
(42.5 mm Max)
7A
8B
8C
8D
8A
7A
8B
8C
8D
8A
© VONN Lighting,2019
Legend
L = Live/Hot/Black
N = Neutral/White
= Ground/Green
•Slip wires through mounting plate (A) before attaching to junction box. Secure
mounting plate (A) to junction box with mounting screws (B).
2. Supply Wires:
Ground Wires:
Connect White (Neutral Wire) from fixture to power White
(Neutral Wire).
Connect Green (Ground Wire) from fixture to supply Green
(Ground Wire).
Twist wires together clockwise and secure with wire
connector (D).
3. Install Sconce
Install fixture to mounting plate (A). Secure fixture with hex
screw (C). Tighten hex screw (C) with hex wrench (E).
ON
ON
Circuit Box
4. Turn Power ON
Turn electricity “ON” at main fuse box.
Connect Black (Line Wire) from fixture to power Black (Hot
Wire).
•
•
•
•
•
•
A
B
C
D
E
1. Install Mounting Plate
WALL
JUNCTION BOX
C
/
