Master HALL 1500 Owner's manual

Brand: Master

Model: HALL 1500

Category: Space heaters

Type: Owner's manual

This manual is also suitable for

RADIATORE AD INFRAROSSI

INFRARED HEATER

RADIATEUR À INFRAROUGES

INFRAROTSTRAHLER

INFRAROODRADIATOR

RADIADOR DE INFRARROJOS

INFRAČERVENÝ ZÁŘIČ

Manuale operativo - Operator's Manual - Mode d'emploi

Bedienungsanleitung - Gebruikershandleiding -

Manual de uso - Manuàl

HALL 1500

4165.250 Ediction 10 Rev. 05

Page is loading ...

SAFETY INFORMATION

MAIN COMPONENTS

REMOVAL OF THE HEATER FROM THE PACKAGE

OPERATION

SAFETY INFORMATION

!!! IMPORTANT: carefully read all the Operator's

Manual before assembling, starting or performing

maintenance operations on the heater. The heater

may cause severe accidents due to burns, fires or

electric discharges.

This heater is portable and is designed for indoor

heating of areas like warehouses, shops and homes.

The heater is compliant with the requirements of

Standard EN 60335-2-30.

• Never install the heater in rooms containing

gasoline, solvents, paints or other highly

inflammable materials or close to curtains.

• Keep the heater away from children and

pets.

• Verify that the supply voltage and frequency

are compliant with the data specified on the

nameplate.

• Always use three-wire grounded extensions

with an adequate section.

• Disconnect the heater from the mains when it

is not in use.

• The heater should not be positioned

immediately below a socket.

• Before leaving the heater unattended, make

sure it cannot be used and always

disconnect it from the mains.

• Never use the heater with programmers,

timers or other devices that could

automatically start it, as fires could break out

if the heater is not covered or located in a

correct position.

• Never use the heater next to bathtubs,

showers or swimming pools.

• Always disconnect the heater from the mains

by pulling the plug out of the wall socket

before servicing, cleaning or repairing the

heater.

• Never perform maintenance operations when

the heater is hot or running.

MAIN COMPONENTS

See fig. 1 Page 2

1)Parabola, 2)Lamp, 3)Protection grille, 4)Cover,

5)Fixing knob, 6)On/Off switche, 7)Cable tie and fuse

holder, 8)Power cable.

REMOVAL OF THE HEATER

FROM THE PACKAGE

• Remove all the packaging materials used for

transportation purposes.

• Remove all the items from the boxes.

• If the heater appears to be damaged, report

the damage to the retailer from which it has

been purchased.

OPERATION

!!! WARNING: carefully read the warnings listed

in section Safety Information in this manual and

follow them carefully to operate the heater in full

safety.

Verify that the power cable is not damaged.

Damaged power cables must be replaced by the

manufacturer or by its technical service or, at any

rate, by a qualified technician trained to prevent all

possible risks. Verify that the technical specifications

of the socket comply with those listed in the

instructions or shown on the nameplate of the heater.

Place the heater on a flat surface.

Do not turn the heater on if the lamp is not in

horizontal position.

STARTING THE HEATER

Connect the power cable to the mains.

Move the switch on the rear of the machine to

position 1. The lamp immediately turn red as soon as

the heater reaches its maximum power.

TURNING THE HEATER OFF

Move the switch to position 0 and disconnect the

heater from the mains. Wait a few minutes to allow it

to cool down.

REGULAR CLEANING AND INSPECTION

TROUBLESHOOTING

TECHNICAL SPECIFICATIONS

REGULAR CLEANING AND

INSPECTION

Before storing the heater for long periods of time,

clean it thoroughly. Always place it in a dry room and

protect it from dust. Before reusing the heater, check

the conditions of the power cable. When in doubt, call

the Technical Assistance.

The heater should always be inspected once a year.

The heater should be serviced by qualified

technicians authorized by the manufacturer.

TROUBLESHOOTING

WARNING: the heater has an internal overvoltage protection.

FAULT CAUSE CORRECTIVE ACTION

The lamp doesn't turn on Blown lamp Replace

The heater doesn't start Blown fuse

Faulty connections (interrupted)

Faulty lamp

Replace

Disconnect the plug and inspect

the connections

Replace

The lamps does not stay on

permanently

Faulty lamp Replace

TECHNICAL SPECIFICATIONS

Power supply 220-240V / 50Hz 110V / 50Hz

Maximum heating power 1500W 1500W

Maximum absorption 6,5A 13,6A

Page is loading ...

Master HALL 1500 Owner's manual

Brand: Master

Model: HALL 1500

Category: Space heaters

Type: Owner's manual

This manual is also suitable for

Download PDF

report

in other languages

italiano: Master HALL 1500 Manuale del proprietario
français: Master HALL 1500 Le manuel du propriétaire
español: Master HALL 1500 El manual del propietario
Deutsch: Master HALL 1500 Bedienungsanleitung
Nederlands: Master HALL 1500 de handleiding
čeština: Master HALL 1500 Návod k obsluze
eesti: Master HALL 1500 Omaniku manuaal

Master HALL 1500 Owner's manual

This manual is also suitable for

Master HALL 1500 Owner's manual

in other languages

Related papers

Other documents