Hinge Pin
and Hitch Pin
Qty: 2
Qty: 2
Qty:2
Qty: 2
463831003
Items to Assemble:
1 Vaporiser Bar
1 Grate
Items to Assemble:
2 Wheel Assemblies
2 Hitch Pins
2 Leg Extenders
Items to Assemble:
2 Leg Assemblies
1 Bottom Shelf
6 carriage Bolts
6 Wing Nuts
Qty: 6
Qty: 6
Place Bottom Shelf and Legs as shown.
After assembling tighten all Wing Nuts.
Right Side:
Attach 2 Carriage Bolts and Wing Nuts in
front and back.
Left Side:
Place 1 Carriage Bolt
and Wing Nut in upper hole only
Items to Assemble:
1 Condiment Basket
Items to Assemble:
1 Grill Lid
2 Hinge Pins
2 Hitch Pins
1 Handle
2 Wing Nuts
1 Logo Plate
Item to Assemble:
1 Wire Shelf
1 Panel
2 Push Pins
Qty: 2
placing tabs into slots on Bottom Shelf.
Attach with push pins.
A
B
Assemble front panel first by
Place Wire Shelf in 3rd hole from top.
A
B
Push Vaporiser Bar down onto rest
in Grill Bottom
Attach Wheels with Hitch Pins
Items to Assemble:
1 Grill Bottom
1 Heat Shield
4 Carriage Bolts
4 Wing Nuts
Qty. 4
Qty.4
Items to Assemble:
2 Shelves
8 Wing Screws
Qty: 8
Items to Assemble:
1 Grease Clip
1 Tank Wire Support Bracket
Correct position of LP tank
and tank wire support
bracket after grill assembly
LP tank is sold separately. Fill and leak check
before attaching to grill and regulator.
See Use & Care to perform the “Burner Flame Check”
and important safety instructions before using.
• Failure to install can in clip will cause hot
grease to drop from bottom of grill with
risk of fire or property damage.
•Tank collar opening must face to front of
cart once tank is attached.
• Failure to install tank correctly may allow
gas hose to be damaged in operation,
resulting in the risk of fire.
Back of GrillBack
of
Grill
Hang grease clip from center of grill bottom.
Use a empty soup can (not included) to hang from grease clip.
Grease Clip
Empty soup
can
Items to Assemble:
1 Lower Warming Rack
1 Upper Warming Rack
A
B
Insert pivot wire of Lower Warming Rack into Lid.
Flex leg wires to insert into Grill bottom.
Insert pivot wire of Upper Warming Rack into lid.
Flex leg wires to insert into loops on Lower Rack.
Leg wires on both Warming Racks
must run underneath surfaces.
Legs snap into loop
B
A
Warming Racks removed for clarity.
1
9
11
10
9
8
4
5
6
7
1
2
3
/