2. NAD
  3. MT 1

NAD MT 1 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the NAD MT 1 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
®
MT 1 MEDIA TUNER
Mounting Instructions
MOUNTING INSTRUCTIONS FOR THE C375BEE
The MT1 is compatible with C375BEE. Using the supplied exible at cable
(FFC), DC power connector and screws, the MT1 can be installed in a C375BEE
by undertaking the following procedure.
Note that if the C375BEE has a PP375 Phono Preamplier Module already
installed, the MT1 and the PP375 can be linked together using the other
supplied FFC.
STEP 1
Pre-install the requisite cables to their respective connector points on the MT1
as shown. Connect the FFC to the MT1’s PHONO port only if the C375BEE has a
PP375 already installed.
STEP 2
Make the following connections:
1 DC POWER connector from MT1 to corresponding P216B in C375BEE’s main
board.
2 FFC from MT1’s ANALOG OUT to P213B on C375BEE’s main board.
3 If the optional PP375 module is installed: FFC from MT 1’s PHONO port to
the corresponding FPC (exible printed circuit) connector of the PP375
module.
Ensure good harnessing by exing and safely contorting the FFC and
DCPOWER connectors.
STEP 3
Remove the dummy cover at the back of the C375BEE and install in its place the
MT1. Use the supplied screws to x into place the MT1.
3
2
1
IMPORTANT!
The MT1 is only compatible with C 375BEE units that have the
0.5Wstandby logo on their rear panels.
Copyright 2015, NAD Electronics International, a division of Lenbrook Industries Limited
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.
No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice.
MDCMT1_QS_V07  SEP 2015
1
2
MOUNTING INSTRUCTION FOR THE C356BEE
The MT1 is compatible with C356BEE. Using the supplied exible at cable
(FFC), DC power connector and screws, the MT1 can be installed in a C356BEE
by undertaking the following procedure.
STEP 1
Pre-install the requisite cables to their respective connector points.
Connect the following
1 DC POWER connector from MT1 to corresponding CB48 on C356BEE’s main
board.
2 FFC from MT1’s ANALOG OUT to CB36 on C356BEE’s main board.
Ensure good harnessing by exing and safely contorting the FFC and DC POWER
connectors.
STEP 2
Remove the dummy cover at the back of the C356BEE and install in its place the
MT1. Use the supplied screws to x into place the MT1.
NOTE
Download the latest MT1 owner’s manual from the Manuals/Downloads tab at
http://nadelectronics.com/products/hi-mdc-modules/MT-1-Media-Tuner-Module
/