Raymarine ST7001+ Quick Reference Manual

Type
Quick Reference Manual

This manual is also suitable for

Distributed by
Any reference to Raytheon or
RTN in this manual should be
interpreted as Raymarine.
The names Raytheon and RTN
are owned by the
Raytheon Company.
ST6001+ Control Unit Quick Reference Guide
Auto mode Track mode
Wind Vane mode
Autopilot adjustments
and
or
or
and
and
1 sec
Basic operation
Entering Track mode (from Auto or Wind Vane mode)
Making course changes
Course
changes
to port
Course
changes to
starboard
Entering Wind Vane mode
10˚
Using AutoTack
Adjusting response level Adjusting keypad and
display lighting
Displaying data pages
AutoTack
to port
AutoTack to
starboard
to accept new heading
Exiting Wind Vane mode
to enter Track mode
and
To make temporary changes:
Use -1 or +1 to adjust response level.
Press disp to return to previous mode.
Use disp to adjust lighting level.
Wait 10 sec to return to previous mode.
D5502-2
then
Default AutoTack = 100˚
Press or
Exiting Track mode
Press or
1 sec
• show first data page
• scroll through available data pages
• return to previous mode
Press to:
then
Entering Auto mode
(Engaging the autopilot)
Returning to Standby
(Disengaging the autopilot)
Returning to previous locked heading
to accept
heading
Document number: 86062-1 (use with handbook: 81190-1)
Date: 11 May 2001
2 sec
x2
2 sec
D5476-1
Compass calibration
Enter Seatrial Calibration
1
Complete the compass deviation correction
2
Align the autopilot heading
3
a
b
Save changes
4
Turn boat in slow circles so:
boat's speed stays below 2 knots
each circle takes at least 2 minutes
To:
save deviation correction
save heading alignment
return to STANDBY mode
Minimum of
2 circles
Keep turning the boat until
you see the DEVIATION screen
Start turning boat
(see below)
Autopilot heading
Autopilot heading
Steering compass
Known
heading
or
or
Adjust the autopilot heading so it shows the
same value as the boat's steering compass
Coarse adjustment: If COG is available from GPS, press to set autopilot heading to COG value,
then fine tune manually (see below).
Fine adjustment: If COG is not available (or after setting heading to COG), align autopilot heading manually:
  • Page 1 1
  • Page 2 2
  • Page 3 3

Raymarine ST7001+ Quick Reference Manual

Type
Quick Reference Manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI