Greenlee CMA-40 User manual

CMA-60

CLAMP-ON CURRENT

ADAPTER

ADAPTADOR

DE CORRIENTE

CON PINZA

ADAPTATEUR DE

COURANT A

PINCES

INSTRUCTION MANUAL

MANUAL DE INSTRUCCIONES

MANUEL D’INSTRUCTIONS

Read and understand all of the instructions and safety

information in this manual before operating or servicing this tool.

Lea y entienda todas las instrucciones y la información sobre

seguridad que aparecen en este manual, antes de manejar estas

herramientas o darles mantenimiento.

Lire attentivement et bien comprendre toutes les instructions et

les informations sur la sécurité de ce manuel avant d’utiliser ou de

procéder à l’entretien de cet outil.

2

Description

The Greenlee CMA-60 Clamp-on Current Adapter is an AC- and DC-current measuring

accessory. It is intended to be connected to any multimeter (purchased separately) capable of

measuring AC and DC millivolts.

The CMA-60 clamp takes a current input and produces a voltage output.

• When measuring current in the 100-amp range, the output is 10 millivolts per amp of input.

The maximum output is 1 volt.

• When measuring current in the 600-amp range, the output is 1 millivolt per amp of input.

The maximum output is 600 millivolts.

Safety

Safety is essential in the use and maintenance of Greenlee tools and equipment. This

instruction manual and any markings on the tool provide information for avoiding hazards and

unsafe practices related to the use of this tool. Observe all of the safety information provided.

Purpose

This instruction manual is intended to familiarize all personnel with the safe operation and

maintenance procedures for the Greenlee CMA-60 Clamp-on Current Adapter.

Keep this manual available to all personnel.

Replacement manuals are available upon request at no charge.

and are registered trademarks of Greenlee Textron.

KEEP THIS MANUAL

CMA-60

3

Important Safety Information

This symbol is used to call your attention to hazards or unsafe practices which could

result in an injury or property damage. The signal word, defined below, indicates the

severity of the hazard. The message after the signal word provides information for

preventing or avoiding the hazard.

SAFETY ALERT SYMBOL

Immediate hazards which, if not avoided, WILL result in severe injury or death.

Hazards which, if not avoided, COULD result in severe injury or death.

Hazards or unsafe practices which, if not avoided, MAY result in injury or property

damage.

Read and understand this material before operating or servicing

this equipment. Failure to understand how to safely operate this

tool can result in an accident causing serious injury or death.

4

Important Safety Information

• Do not operate with the case open.

• Before opening the case, remove the jaw from the circuit and shut off the unit.

Failure to observe these warnings can result in severe injury or death.

• Do not attempt to repair this unit. It contains no user-serviceable parts.

• Do not expose the unit to extremes in temperature or high humidity.

See Specifications.

Failure to observe these precautions can result in injury and can damage the unit.

Electric shock hazard:

• Do not use the unit if it is wet or damaged.

• Use test leads or accessories that are appropriate for the application. See the

category and voltage rating of the test lead or accessory.

• Inspect the test leads or accessory before use. The item(s) must be clean and dry,

and the insulation must be in good condition.

Failure to observe these warnings can result in severe injury or death.

Electric shock hazard:

Contact with live circuits can result in severe injury or death.

CMA-60

5

Identification

1. Jaws

2. Lever

3. DC Zero Adjustment Knob

4. Leads

6

7

1

4

2

5

3

8

5. Low Battery Indicator

6. Power ON Indicator

7. Selector

8. Polarity Indication

6

Operation

Electric shock hazard:

Contact with live circuits can result in severe injury or death.

Note: The CMA-60 requires a multimeter (purchased separately) capable of reading AC and

DC millivolts.

1. See the instruction manual supplied with the multimeter.

2. Connect the CMA-60 to the voltage input terminals of your multimeter.

Observe polarity.

3. Set the multimeter and the CMA-60 according to the Settings Table.

Settings Table

*Before measuring the current, use the Zero Adjustment Knob to set the meter’s display

to zero.

4. See Typical Measurements for illustrations of typical uses.

5. Test the unit on a known functioning circuit or component.

• If the unit does not function as expected on a known functioning circuit, replace the

battery.

• If the unit still does not function as expected, send the unit to Greenlee for repair.

6. Take the reading from the circuit to be tested. If the resolution is not satisfactory, remove

the jaw from the circuit and change to the next lower range.

tnerruCgnitteSretemitluMgnitteS06-AMC

)CA(nwonknU)CA(stlovilliMA006

)CD(nwonknU)CD(stlovilliM*A006

)CA(spmA006ot001)CA(stlovilliMA006

)CD(spmA006ot001)CD(stlovilliM*A006

)CA(spmA001ot0)CA(stloVA001

)CD(spmA001ot0)CD(stloV*A001

CMA-60

7

Typical Measurements

Clamp Around

Line Splitter

Clamp Around Wire

Notes:

• Clamp the jaw around one conductor only.

• Close the jaw completely.

• Center the wire in the jaw for highest accuracy.

Notes:

• The Greenlee 93-30 Line Splitter is divided. One section

renders amps; the other renders amps multiplied by 10.

• Close the jaw completely.

• Center the line splitter in the jaw for highest accuracy.

Multimeter set to

read AC or DC voltage.

Note: Current flowing through

the jaw in the direction

indicated by the arrow

produces a positive reading.

Multimeter set to

read AC voltage.

8

Accuracy

• See the Specifications section for operating conditions.

• Accuracy is specified as follows: ± (a percentage of the reading + a fixed amount)

at 23 °C ± 5 °C (73.4 °F ± 9 °F), 0% to 75% relative humidity.

• Accuracy is for the CMA-60 only. See the instruction manual supplied with your multimeter

for its accuracy.

Accuracy Table

*Accuracy is specified for DC and 45 to 400 Hz AC.

Specifications

Measurement Range: 0A to 600A

Voltage Output:

100 Amp Range: 10 mV output per 1 amp input

600 Amp Range: 1 mV output per 1 amp input

Output Impedance: 100 kΩ

Temperature Coefficient: 0.2 x (specified accuracy) per °C below 18 °C or above 28 °C

Operating Conditions: 0 °C to 50 °C (32 °F to 122 °F), 0% to 75% relative humidity

Elevation: 2000 m (6500') maximum

Indoor use only

Storage Conditions: –20 °C to 60 °C (–4 °F to 140 °F), 0% to 80% relative humidity.

Remove battery.

Jaw Opening: 35 mm (1.38")

Battery: 9-Volt battery (NEDA 1604, JIS 006P or IEC 6LF22)

Pollution Degree: 2

Overvoltage Category: Category II, 600 Volts

egnaRtupnI*ycaruccA

A001A001ot0)A2+%2(±

A006

A004ot001)A2+%2(±

A006ot004)A2+%3(±

CMA-60

9

1. Disconnect the unit from the circuit. Turn the unit OFF. Disconnect the unit from the

multimeter.

2. Remove the screw from the battery compartment cover.

3. Remove the battery compartment cover.

4. Replace the battery (observe polarity).

5. Replace the cover and screw.

Before opening the case, remove the jaw from the circuit and shut off the unit.

Failure to observe this warning can result in severe injury or death.

Battery Replacement

10

Greenlee Textron / Subsidiary of Textron Inc. 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070

Page is loading ...

CMA-60

27

Greenlee Textron / Subsidiary of Textron Inc. 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070

For technical assistance: 800/435-0786

Greenlee Textron / Subsidiary of Textron Inc.

4455 Boeing Drive, Rockford, IL 61109-2988 USA

Technical / Customer Service (International): 815/397-7070 • Fax: 815/397-1391

Customer Service (North America): 800/435-0786 • Fax: 800/451-2632, 815/397-1865

Canada Fax: 800/524-2853

Lifetime Limited Warranty

Greenlee warrants to the original purchaser of these goods for use that these products will be free from defects in

workmanship and material for their useful life, excepting normal wear and abuse. This warranty is subject to the same

terms and conditions contained in Greenlee’s standard one-year limited warranty.

For all Test Instrument repairs, ship units Freight Prepaid to:

Greenlee Textron, 4411 Boeing Drive, Rockford, IL 61109-2932 USA.

Mark all packages: Attention TEST INSTRUMENT REPAIR. For items not covered under warranty (such as dropped,

abused, etc.), repair cost quote available upon request.

Note: Prior to returning any test instrument, please check replaceable batteries or make sure the battery is at full charge.

Garantía limitada de por vida

Greenlee garantiza al comprador original de estos productos para su uso que estos productos estarán libres de

defectos de mano de obra y materiales durante toda su vida útil, exceptuando el desgaste normal y el abuso. Esta

garantía está sujeta a los mismos términos y condiciones contenidos en la garantía estándar limitada de Greenlee de

un año de duración.

Para reparación de instrumentos de verificación, envíe las unidades con flete pagado a:

Greenlee Textron, 4411 Boeing Drive, Rockford, IL 61109-2932 EE. UU.

Marque todos los paquetes: Atención TEST INSTRUMENT REPAIR (Reparación de instrumentos de verificación). Para

artículos no cubiertos por la garantía (tales como los que se han dejado caer o han sido maltratados, etc.) se puede

cotizar el costo de la reparación a pedido.

Nota: Antes de enviar cualquier instrumento de prueba, revise por favor las pilas o asegúrese de que estén totalmente

cargadas.

Garantie à vie limitée

La société Greenlee garantit à l’acheteur d’origine de ces produits que ces derniers ne comportent aucun défaut

d’exécution ou de matériau pour la durée de leur vie utile, sauf l’usure normale. Cette garantie est assujettie aux mêmes

conditions que celles contenues dans les modalités et conditions de la garantie limitée standard d’un an de Greenlee.

Pour toutes les réparations d’instruments de mesure, expédiez l’appareil en port payé à l’adresse suivante :

Greenlee Textron, 4411 Boeing Drive, Rockford, IL 61109-2932, États-Unis.

Sur tous les colis, inscrivez : Attention : TEST INSTRUMENT REPAIR (Réparation d'instrument de mesure). Lorsque

les articles ne sont pas protégés par une garantie (comme si l’appareil est échappé, s’il est soumis à un usage abusif,

etc.), une soumission pour le prix de réparation sera présentée sur demande.

Remarque : Avant de renvoyer un appareil de mesure, vérifiez la pile et assurez-vous qu’elle est chargée au complet.

Greenlee CMA-40 User manual

This manual is also suitable for

Greenlee CMA-40 User manual

in other languages

Related papers

Other documents