Fringe Screw FS10L18ORB Installation guide

Type
Installation guide
Fringe Screw™
Instruction for Use
1. Identify Loose Hinge Screws That Will Not Tighten.
Common symptoms of loose door hinges include
Binding, sagging or crooked door.
Door won’t latch or stay open/closed.
Hinge pulling away from door or jamb as shown
in the figure detail.
2. Prepare Door For Hinge Screw Replacement.
Open the door so that all hinge screws are
accessible.
Place a shim, such as a book or magazine,
under the bottom of the door.
BOOK
BOOK
Fringe Screw™
Instruction for Use
3. Remove Stripped Hinge Screws One at a Time.
If badly stripped screws can not be removed, the entire hinge side (door, jamb,
or both) with the stripped screws has to be removed.
Have an assistant hold the door steady.
Remove all the screws that will come out and then apply outward pressure on
the hinge while turning the stripped screw(s).
Reinstall the hinge side in the screw holes that are not stripped.
Fringe Screw™
Instruction for Use
4. Replace Hinge Screw With Fringe Screw™.
Fringe Screw™
The screw should be snug, but use caution not to over-tighten as this could
further damage the screw hole.
Repeat steps 3. and 4. for each loose screw identified in step 1.
Fringe Screw™
Instruction for Use
Cautions
Use caution when repairing a door.
Be watchful of fingers or other body parts getting pinched or stuck in door
jamb.
Doors are heavy and could fall and injure someone if not properly
secured.
If possible, have an assistant hold the door steady when installing Fringe
Screw™.
Fringe Screw™
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Fringe Screw FS10L18ORB Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI