Keurig B100 User manual

Brand: Keurig

Model: B100

Category: Coffee makers

Type: User manual

Keurig B100 is a single cup brewer that allows you to brew a variety of coffee, tea, and hot cocoa beverages. It features a 40-ounce water reservoir, a removable drip tray, and a variety of programmable settings. The Keurig B100 is easy to use and maintain, and it can help you save time and money on your favorite beverages.

Here are some of the features and benefits of the Keurig B100:

Brews a variety of coffee, tea, and hot cocoa beverages
40-ounce water reservoir
Removable drip tray
Programmable settings
Easy to use and maintain
Can help you save time and money on your favorite beverages

Here are some of the features and benefits of the Keurig B100:

Brews a variety of coffee, tea, and hot cocoa beverages
40-ounce water reservoir
Removable drip tray
Programmable settings
Easy to use and maintain
Can help you save time and money on your favorite beverages

Instructions for De-Scaling your Keurig

B100 Home Brewer with Vinegar

a. PREPARE

Step 1: Make sure you have at least 64 ounces of white vinegar on hand. You will

also need an empty sink and a ceramic mug (do not use a paper cup.)

Step 2: Turn power “OFF”, unplug Brewer and drain the Brewer following the

instructions below.

DRAINING YOUR KEURIG BREWER

CAUTION: Water is hot, please turn off brewer, unplug it and allow water to

cool before draining.

Step 1: Make sure Brewer is unplugged! Carry Brewer to sink making sure that it

stays upright.

Step 2: Remove the Drain Cap on rear of Brewer and, if present, remove Charcoal

Filter from the Water Fill Area.

Step 3: Rest the rear of the Brewer flat on the counter with the drain positioned

over the sink and allow Brewer to drain. For best results, do not tilt beyond a 90°

angle.

Step 4: Once water is drained, replace the Drain Cap.

b. FILL AND CLEAN

Step 1: Plug Brewer in and turn power “ON”.

Step 2: Pour approximately 64 oz of the vinegar into the Brewer until 4 beeps

signal the tank is full.

Step 3: Wait about 6 – 8 minutes for the vinegar to heat up and the green

“READY” light to go on.

Step 4: Place a ceramic mug in the Drip Tray and run a brew cycle. DO NOT USE

A K-CUP…just press the Brew button.

Step 5: Repeat the brew process 4 or 5 times pouring the contents of the mug

back into the Brewer after each cycle.

Step 6: Now let the Brewer stand for 4 hours while still on.

Step 7: Place a ceramic mug on the Drip Tray and run 4 brew cycles, pouring the

contents of the mug

into the sink after each cycle.

Step 8: Turn the brewer off, let the remaining vinegar cool, and drain the brewer as

instructed above.

CAUTION: Vinegar may still be hot. Remember to replace the Drain Cap.

c. RINSE

Step 1: Fill the brewer with hot tap water.

Step 2: Power up brewer.

Step 3: Wait about 6-8 minutes for the water to heat up and the Green “Ready”

Light to go on.

Step 4: Place a ceramic mug on the Drip Tray and run a brew cycle.

Step 5: Repeat brew process 4 times for a total of 5 cycles.

Step 6: Drain the brewer as instructed above.

CAUTION: Water may be hot. Remember to replace the Drain Cap.

Step 7: You may need to rinse again to eliminate any residual taste.

For any additional questions regarding your B100 Single Cup Brewer, contact AT HOME

CUSTOMER SERVICE at 1-866-901-BREW (2739).

Keurig B100 User manual

Brand: Keurig

Model: B100

Category: Coffee makers

Type: User manual

Here are some of the features and benefits of the Keurig B100:

Brews a variety of coffee, tea, and hot cocoa beverages
40-ounce water reservoir
Removable drip tray
Programmable settings
Easy to use and maintain
Can help you save time and money on your favorite beverages

Download PDF

report

Keurig B100 User manual

Keurig B100 User manual

Related papers

Other documents