THESOURCE Bubble String Lights Owner's manual

Type
Owner's manual
INCLUDED
7m string length
50 attached bubble lights
Instruction manual
FEATURES
IP65 – water resistant
Use indoor or outdoor
GETTING STARTED
OPERATING INSTRUCTIONS
1. Open the battery cover.
2. Install 3 AA batteries (sold separately) following the polarity markings.
DO NOT mix old and new batteries; do not mix alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries.
3. Close the battery cover and switch lights ON.
Press the button to switch between light modes:
1–Combination
2–Waves
3–Sequential
4–Slow glow
5–Running water
6–Slow fade
7–Twinkling
8–Solid ON
9–OFF
WARNING
LEDs are not replaceable
DO NOT install batteries while the product is in the packaging
Fully unwind lights and uncoil the cable before turning on
Remove batteries when not in use
DO NOT use if the product is damaged
DO NOT expose to direct heat, flame or immerse in water
DO NOT attempt to power and further string lights from this
product
DO NOT attempt to remove bulbs, LED bulbs cannot be replaced
Batteries should be removed and replaced by adults only
Protect product from sharp or potentially damaging objects to avoid
damage to the wire’s insulation
8085217
BUBBLE STRING LIGHTS
Instruction Manual
Imported by:
The Source, Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
www.thesource.ca
© 2020 The Source. All rights reserved.
Please
Recycle
  • Page 1 1

THESOURCE Bubble String Lights Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI