2. Chief
  3. ASP401

Chief ASP401 Installation guide

  • Hello! I've reviewed the installation instructions for the Chief ASP-401 Individual Control System, a single pole double throw switch for Chief electric lifts. The document provides details on unpacking the components, wiring the switch, and installing it into a single gang box. I can answer your questions about the product and its setup.
  • What type of switch is the ASP-401?
    What is the ASP-401 designed for?
    What wires does the ASP-401 have?
INSTALLATION INSTRUCTIONS
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8820-000009 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
2/10/09
INDIVIDUAL CONTROL SYSTEM
ASP-401
The ASP-401 is a single pole, double throw (SPDT) switch designed for use with any Chief® electric lift.
Unpack and check contents (See Figure 1):
Installation:
WARNING:
IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
1. Connect black wire to common (See Figure 2).
2. Connect blue wire to up.
3. Connect red wire to down.
4. Install switch in single gang box with red wire on top and secure using two screws (provided).
Figure 2: Dimensions and Wiring
(1) Cover, aluminum with rocker switch (2) Screw, oval head, 6-32 x 1/2"
Figure 1: Parts
A(1) B(2)
[Cover, aluminum with rocker switch] 6-32 x 1/2"
4 1/2"
2 3/4"
Red = DOWN
Black = COMMON
Blue = UP
/