Christie 123-003104-03 Operating instructions

Category
Car kits
Type
Operating instructions
MicroTiles™ Screen Tape Instruction Sheet 1 of 3
020-100564-01 Rev. 1 (04-2010)
MicroTiles™ Screen Tape
Instruction Sheet
INTRODUCTION
Upon completion of a MicroTiles Array, the top corners of some of the display units may be exposed
(Figure 1).
There is a possibility of light infiltration through the exposed corners of the screen which may cause
bright spots on the active area of the screen. To correct this potential problem, a 10cm piece of tape is
added to those exposed top corners of the screen to increase the opacity and significantly reduce and
possibly eliminate any light from entering the display unit from that point.
KITS REQUIRED
123-104106-01 - MicroTiles Setup Kit
Exposed Top
Corners
Exposed Top
Corners
Figure 1 Sample Array with Exposed Top Corners Circled
2 of 3 MicroTiles™ Screen Tape Instruction Sheet
020-100564-01 Rev. 1 (04-2010)
TOOLS REQUIRED
Scissors
INSTRUCTIONS
1. Remove the affected screen using the proper screen removal procedures. Refer to Christie® Micro-
Tiles User Manual (p/n 020-100329-xx).
2. Cut 10cm of tape from the 40cm piece included in the MicroTiles Setup Kit (Figure 2).
3. Align the tape to the existing tape using the front of the screen as a guideline. Ensure there is
approximately 5cm of tape on either side of the corner (Figure 3).
10cm
30cm
Figure 2 Cut 10cm of Tape
Figure 3 Align Tape to Front Edge of Screen
MicroTiles™ Screen Tape Instruction Sheet 3 of 3
020-100564-01 Rev. 1 (04-2010)
4. Apply tape to the sides of the screen. NOTICE: Make sure that the new tape does not protrude
past the front of the screen (Figure 4).
5. Re-install screen onto the display unit. Refer to Christie® MicroTiles User Manual (p/n 020-
100329-xx).
Figure 4 Apply Tape to Screen Frame
  • Page 1 1
  • Page 2 2
  • Page 3 3

Christie 123-003104-03 Operating instructions

Category
Car kits
Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI