2. BOXLIGHT
  3. LD12-CO2

BOXLIGHT LD12-CO2 Owner's manual

  • Hello! I've reviewed the user manual for the Boxlight LD12-CO2 CO2 gas probe. This document details the probe's specifications, including its 0 to 5000 ppm range and ±50 ppm accuracy. It also walks through the preparation steps, including the 24 hour warm-up for best accuracy and the 30 seconds warm-up prior to each measurement. The manual also explains how to use the probe with the GlobiLab software. I am ready to answer your questions!
  • What is the measurement range of the CO2 probe?
    What is the accuracy of the CO2 probe?
    How long does the probe need to warm up?
    What should the Labdisc display in a ventilated room after the warm-up time?
External Carbon Dioxide Probe
Specification
1. Probe range: 0 to 5000 ppm
2. Probe accuracy: ±50 ppm
What’s in the Pack
CO₂ gas probe
Preparing the Probe
1. Connect the CO₂ probe adapter to the Micro-USB external probe socket on the Labdisc. Make sure that the USB sign on
the adapter cable connector is facing up.
2. Turn on the Labdisc.
3. If this is the first time you are using the CO₂ probe – connect the Labdisc to its AC/DC adapter and let the probe run for 24
hours warm-up in order to reach best accuracy.
4. Click on the probe key located above the external probe socket where you’ve plugged in the CO₂ probe. If this key has
two probe icons, you might need to press it twice to show the magnetic field probe.
5. The probe needs 30 seconds to “warm-up”. During this time, the Labdisc will show
5000 ppm. After the “warm-up” time the Labdisc will display 350 to 600 ppm in a ventilated room.
6. Using the CO₂ probe, the Labdisc will not enter “sleep-mode” to avoid warming up the probe for 30 seconds before each
measurement.
7. The Labdisc shows the CO₂ probe readings in “ppm” units.
Using the CO₂ Probe with the GlobiLab Software
1. Open the GlobiLab software.
2. Make sure it is connected to the Labdisc via USB or Bluetooth communication.
3. Click the SETUP icon to open the Logger setup dialog box.
4. The CO2 probe is automatically identified by the software.
5. To select this probe, simply click on selection button to the left of the CO₂ probe
icon.
/