2. Bel Air Lighting
  3. 51404 BK

Bel Air Lighting 51404 BK, 51404 User manual

  • Hello! I've reviewed the assembly instructions for the Pendant Light model 51404. This document provides step-by-step guidance on assembling the light, including attaching the chain, mounting unit, and canopy, as well as making electrical connections. I'm ready to answer any questions you may have about its installation process.
  • What should I do if there's a defect in the wire?
    What should I do before starting the installation?
    What type of bulb does this fixture use?
Fixture
TOOLS REQUIRED
CAUTION
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
• Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect in
the wire, do not attempt installation.
• Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning o the circuit breaker or by
removing the fuse at the fuse box.
page 1
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
Socket Ring
Chain
Canopy
Screw Collar Ring
Mounting Unit Mounting Screws Wire Nuts
PENDANT LIGHT (CHAIN)
Assembly Instructions
Model:51404
Glass
page 2
STEP 1
STEP 2
Use the mounting screws to attach the mounting
unit to the junction box
STEP 3
Pass the chain and the branchwires through the
screw collar ring and canopy. Feed the branchwires
through the pipe nipple on the mounting unit and
attach the end of the chain to the mounting unit.
PENDANT LIGHT (CHAIN)
Assembly Instructions
Model:51404
Attach the end of the chain to the loop on the fixture.
page 3
STEP 4
Make the electrical connection from the junction
box to the fixture. Connect the ground wire to the
mounting unit using the preinstalled green ground
screw. Then, connect the positive, negative and
ground wires with the supplied wire nuts. Secure
with electrical tape
Connect Clear, Brown, Gold or
Black Parallel Wire without tracer
(round & smooth) or Black Fixture
Wire to:
Black or Red Supply Wire or
Insulated Wire (other than green)
with copper conductor.
Connect Clear, Brown, Gold or
Black *Parallel Wire with tracer
(square & ridged) or White Fixture
Wire to:
White Supply Wire or Insulated
Wire (other than green) with silver
conductor
Copper
Silver
Smooth
Ridged
STEP 5
Secure the canopy to the mounting unit with the
screw collar ring.
STEP 6
Install bu lg
b
la
(n
ss
otoin
nc
tl
h
u
e
de
sd
oc
)ket and secure it with socket ring.
PENDANT LIGHT (CHAIN)
Assembly Instructions
Model:51404
Place the
Install the bulb E26 60W MAX(not included).
/