How to Operate
Problem
Signal light
is off
Not working
• Controller’s battery may be
too low to operate
• Did not press the “M” button
• Patches not connected to skin
• Intensity level set too low
• Patches are damaged -
inadequate conductive gel
• Patches not placed properly
• Please put the controller on charge
• Please press the “M” button to begin massage
• Place the patched properly
• Press “+” on button to gradually enhance
intensity
• Clean the patches and replace with new ones
• Turn off the device, and relocate the patches
to other areas
Possible Causes Solution
Charging
Plug the micro USB end of the USB cable into the USB charging port at the bottom of the
EMS Controller. Plug the other end of the USB cable into a 5V USB plug.
The charging indicator light turns red when it is on charge and light off when it is fully charged.
After being fully charged for 1 hour, the device can work continuously for 200 minutes.
If the device becomes unresponsive to the power button, the battery may be too low to
operate. Please put the device on charge.
1.
2.
3.
4.
How to use
Connect the patches to the controller.
Peel the protective film off the patches, and then place them on your skin.
Press and hold the “M” button for 2 seconds to begin massage. The blue light will be on.
10 intensity levels available: press “+” to increase intensity; “-“ to decrease. The power-on
default as level one.
Press the “M” button to switch the massage mode. 5 cyclical modes: blue light flashes once
for the automatic cycle mode, blue light flashes twice for the knocking mode, blue light
flashes 3 times for the kneading mode, blue light flashes 4 times for the tui-na mode, blue
light flashes 5 times for the massage mode. Automatically switched off after 30 minutes of
use. Press and hold the “M” button for 2 seconds to restart.
Press and hold the “M” button for 2 seconds to turn off. The blue light will be off.
Please be reminded to stick the protective film onto the patches after use.
1.
2.
3.
4.
5.
6.
7.
Note
You can only adjust the mode and intensity level when the device is on and when the patches
are in contact with the skin.
Electrode gel pad can be used for around 30 times. Do not place and remove from the skin if
you do not intend to use it.
If the patches are not properly placed on skin, the skin being too oily or wet, or if the patches
are too damaged to function, there could be mild discomfort.
•
•
•
Maintenance
Do not store the device in humid or hot places.
Do not immerse the device or connection wire in water.
If the patches are dirty or lose their viscosity, wipe them gently with a piece of damp cloth, or
place them under running water. Do not use irritating soaps. Allow to dry thoroughly before use.
•
• .
•
Recommended Usage
FAQs and Solutions
Once or twice daily; each session should not exceed 30 minutes.•