Thermon ET-4S User manual

Type
User manual

Below you will find brief information for ET-4S. This document provides installation instructions for the ET-4S end termination kit, designed for use with Thermon self-regulating heating cables and intended for use in ordinary locations. It outlines the necessary steps for preparing the cable end, installing the heat shrink tube, and ensuring correct sealing. The kit includes an end cap that needs to be shrunk with a heat gun until it is completely sealed to the cable size and the encapsulant has flowed out. Additionally, there is a note regarding not installing the termination in areas exposed to standing water and guidance on roof and gutter applications. The instructions emphasize the importance of using ground-fault protection and complying with relevant electrical code.

Below you will find brief information for ET-4S. This document provides installation instructions for the ET-4S end termination kit, designed for use with Thermon self-regulating heating cables and intended for use in ordinary locations. It outlines the necessary steps for preparing the cable end, installing the heat shrink tube, and ensuring correct sealing. The kit includes an end cap that needs to be shrunk with a heat gun until it is completely sealed to the cable size and the encapsulant has flowed out. Additionally, there is a note regarding not installing the termination in areas exposed to standing water and guidance on roof and gutter applications. The instructions emphasize the importance of using ground-fault protection and complying with relevant electrical code.

KIT COMPONENTS
ITEM QTY. DESCRIPTION
A
MODEL
1ET-4S END CAP
A
KIT STYLE : ET-4S
INSTALLATION INSTRUCTIONS
End Termination Kit for Overjacketed
In Ordinary Locations.
OVERJACKET METALLIC BRAID
DIELECTRIC INSULATION
(TAPE BACK )
1. Remove 1/2" ( 13 mm) of the overjacket from the cable end and trim away exposed braid with scissors. Cover braid by
wrapping with tape.
HEATING MATRIX
(DO NOT EXPOSE)
2. Slip the ET-4S heat shrink tube over the cable end. Shrink the ET-4S end cap with a heat gun, uniformly applying heat
to the end cap. Heat until the end cap has completely shrunk down to the cable size, and the encapsulant has flowed out
of the end.
1/2 "
ET-4S END CAP HEAT GUN
ET-4S END CAP
or eqivalent to permanently mount end termination
water. Use Thermon cable roof fastener RG-CRF
NOTE:
For roof and gutter applications do not install end
termination where it can be exposed to standing
HEATING CABLE
ENCAPSULANT
SEMI-CONDUCTIVE
07/04
Thermon Self-Regulating Heating Cables,
above water level.
  • Page 1 1

Thermon ET-4S User manual

Type
User manual

Below you will find brief information for ET-4S. This document provides installation instructions for the ET-4S end termination kit, designed for use with Thermon self-regulating heating cables and intended for use in ordinary locations. It outlines the necessary steps for preparing the cable end, installing the heat shrink tube, and ensuring correct sealing. The kit includes an end cap that needs to be shrunk with a heat gun until it is completely sealed to the cable size and the encapsulant has flowed out. Additionally, there is a note regarding not installing the termination in areas exposed to standing water and guidance on roof and gutter applications. The instructions emphasize the importance of using ground-fault protection and complying with relevant electrical code.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI