2. Thermon
  3. ET-4S
ET-4S

Thermon ET-4S User manual

  • Hello! I'm your chat assistant. I have reviewed the installation instructions for the Thermon ET-4S End Termination Kit. This document provides guidance on installing the end termination for self-regulating heating cables. The instructions cover the preparation steps, heat shrink application, and safety considerations. I'm ready to answer your questions about the document content or the mentioned kit.
  • What is the first step in preparing the cable for termination?
    How is the ET-4S end cap applied?
    What should be avoided when installing the end termination for roof and gutter applications?
KIT COMPONENTS
ITEM QTY. DESCRIPTION
A
MODEL
1ET-4S END CAP
A
KIT STYLE : ET-4S
INSTALLATION INSTRUCTIONS
End Termination Kit for Overjacketed
In Ordinary Locations.
OVERJACKET METALLIC BRAID
DIELECTRIC INSULATION
(TAPE BACK )
1. Remove 1/2" ( 13 mm) of the overjacket from the cable end and trim away exposed braid with scissors. Cover braid by
wrapping with tape.
HEATING MATRIX
(DO NOT EXPOSE)
2. Slip the ET-4S heat shrink tube over the cable end. Shrink the ET-4S end cap with a heat gun, uniformly applying heat
to the end cap. Heat until the end cap has completely shrunk down to the cable size, and the encapsulant has flowed out
of the end.
1/2 "
ET-4S END CAP HEAT GUN
ET-4S END CAP
or eqivalent to permanently mount end termination
water. Use Thermon cable roof fastener RG-CRF
NOTE:
For roof and gutter applications do not install end
termination where it can be exposed to standing
HEATING CABLE
ENCAPSULANT
SEMI-CONDUCTIVE
07/04
Thermon Self-Regulating Heating Cables,
above water level.
/