Carlton CVC002 Quick start guide
- Category
- Vacuum cleaners
- Type
- Quick start guide
CVC002
1. Power cord 8. Clip
2. On/Off Switch pedal 9. Vacuum tube
3. Accessory storage cabinet 10. Brush
4. Power cord rewind pedal 11. Flexible vacuum tube
5. Dust indicator 12. Integrated brush and nozzle
6. Hose socket 13. Hose handle
7. Front cover
8
7
6
5
3
4
11
9
2
1
10
12
13
We continually strive to improve our products, specifications may change without prior notice.
Mains supply: 230V~50Hz
Nominal power: 1200W
Maximum power: 1400W
Vac doc 2.qxd 23/01/02 09:09 Page 1
or
Operating your vacuum cleaner:
1. Connect the flexible vacuum tube (11) to the
hose socket (6).
2. Connect the vacuum tube (9) to the flexible
vacuum tube (11).
3. Connect the brush (10) to the
vacuum tube (9) for use on a hard floor or carpet.
Alternatively, open up the accessory storage
cabinet (3), and attach the integrated brush and
nozzle (12) to the vacuum tube (9) for use on
sofas or in small spaces.
4. Insert the plug into a mains socket. Press the
on/off switch pedal (2). Adjust the power using the
handle of the hose (13).
5. Carry the unit by opening the accessory
storage cabinet (3) and using the handle
underneath.
6. Press the power cord rewind pedal (4) to
wind the power cord back into the vacuum
cleaner.
Safety Warnings:
Read all instructions before you use the vacuum cleaner.
Make sure that the dust bag is properly installed before you switch on.
Do not vacuum water or inflammable liquids.
Do not vacuum burning material or ashes.
Do not operate your vacuum cleaner if there are any blockages in the pipes or brush.
Do not use or store the vacuum cleaner in high temperatures.
Do not allow young children to use the vacuum cleaner.
Always turn your vacuum off immediately if there is any abnormal noise or smell or if it
becomes broken in any way.
Do not attempt to carry out repairs yourself. Always contact a qualified repair agent.
Do not use the vacuum without a motor filter fitted.
Always empty the dust bag when the dust indicator is red.
If the supply cord is damaged, it must be replaced by a service engineer or a similarly
qualified person in order to avoid a hazard.
The unit must be protected by a 13 amp fuse.
Maintenance:
Replace the dust bag when the dust indicator (5) turns red.
Open the front cover by pressing the lock clip (8), take out the bag holder and then
remove the dust bag.
The front cover will not close until the dust bag and holder have been replaced properly
back inside.
Clean the inlet and outlet motor filter regularly using warm water. If the filter is damaged in
any way it should be replaced immediately. Make sure that the vacuum is dis-connected
from the mains supply before you attempt to clean or change any parts.
8
7
6
5
3
4
11
9
2
1
10
12
13
Vac doc 2.qxd 23/01/02 09:09 Page 2
-
1
-
2
Carlton CVC002 Quick start guide
- Category
- Vacuum cleaners
- Type
- Quick start guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI