ParaBody 884101 Assembly Instructions

Brand
ParaBody
Model
884101
Type
Assembly Instructions
884101 SAFETY RAIL ATTACHMENT
ASSEMBLY INSTRUCTIONS
II
Part # 6810701
1 Re~rision: 6/7/99
Please note:
[iMPORTANT N’~)TES.[
WELCOME TO THE WORLD OF
* Thank you for purchasing the Parabody 884101 SAFETY RAII, ATTACHMENT. Please
read these instructions thoroughly and keep them for future reference., qttis product must
be assembled on a flat, level surface to assure its proper function.
We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy
water. Touch-up paint can be purchased from your Parabody customer service representative
at (800) 328-9714.
There is a risk assumed by individuals who use this type of equipment. To minirnize risk, please
follow these rules:
1. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
2. Do not allow minors or children to play on or around this equipment.
3. Exercise with care to avoid injury. ..
4. If unsure of proper use of equipment, call your local Parabody distributor or call the
Parabody customer service department at (800) 328-9714.
5. Consult a physician before beginning any exercise program.
I B’,0]t Length Ruler I
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF TIlE HEAD OF THE BOLT.
BOLT LENGTH RULER:
....
BOLT LENGTH
[
1/2
[
1/2
] 1/2 [ 1/2
I 1/2 l 1/2
3 4
0
1 2
I , , , , , I_l_l I , I
KEY
1
2
3
4
I
PARTS LIST |
PART #
DESCRIPTION
6807602
LEFT SAIqI~
r
RAIL
6807702
RIGHT SAFETY RAIL
6824601
~%ii7
~
3-1/4 X 1-3/4" GLIDE
13-1/2 X 1-5/8" RUBBER STRIP
1
1
6
2
FIGURE 1
/
STEP 1:
¯
Attach six 3-1/4 X 1-3/4" GLIDES (3) to the LEFT & RIGHT SAFETY RAILS (1 & 2) as shovnl in FIGURE 1, using
following steps:
¯ Thoroughly clean all surfaces where the 3-1/4 X 1-3/4" GLIDES (3) are to be attached.
¯ Remove the 3-1/4 X 1-3/4" GLIDES (3) from the paper backing and firmly apply them to all shown surfaces.
FIGURE 2
STEP 2:
¯
Attach two 13-1/2 X 1-5/8" RUBBER STRIPS (4) to the LEFT & RIGHT SAFETY RAILS (1 & 2) as shown in FIGURE
2,
1/2 [
1/2 [
1/2
I
1/2 [
1/2 [
1/2 [
6
I [ I
I
FIGURE 3
STEP 3:
¯ Assemble the LEFT & RIGHT SAFETY RAILS (1 & 2) to the UPRIGHT FRAMES as shown in FIGURE
Thank you for purchasing the Parabody 884101 SAFTEY RAIL ATTACttMENT. If unsure
of proper use of equipment, call your local Parabody distributor or call the Parabody cus-
tomer service department at (800) 328-9714.
5
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

ParaBody 884101 Assembly Instructions

Brand
ParaBody
Model
884101
Type
Assembly Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents