CK30 and CK31 Handle Instructions
*943-079-001*
P/N 943-079-001
CK30 and CK31 Handle
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2006 Intermec Technologies
Corporation. All rights reserved.
To clean the handle
Remove the handle screw and take
the handle off the CK30 or CK31.
Use a damp cloth to clean the
bottom surface of the computer
and the mounting surface on the
handle.
Press and hold the trigger to
expose the magnet. Use adhesive
tape to remove any metal shavings
from the magnet surface.
3
2
1
Magnet
Instructions
Cleaning the Handle
Use these instructions to install the handle on a CK30 or CK31 Handheld Computer.
To install the handle
(CK31 only) Remove the adhesive backing
from the spacer.
(CK31 only) Insert the spacer on the
CK31 handle and press to make sure it is
securely attached.
1
Do not overtighten the handle screw.
You may damage the threads or cause
the trigger mechanism to jam.
2
Installing the Handle
Place the handle on the computer.
Tighten the screw so the handle does not move.
If you have a torque screwdriver, tighten the screw to
1.26 Nm (12 in-lb) maximum.
3
4
Spacer
Installing the Handle (continued)
Installing the Handle
/