Autopage Car-Pro CPX-RS1 Owner's manual

Brand: Autopage

Model: Car-Pro CPX-RS1

Category: Car alarm

Type: Owner's manual

AUG./15/2003

5 1 0 U S A

C a r - P r o

by:

MODEL CPX-RS1

REMOTE ENGINE STARTER

OWNER’S MANUAL

SVMASTER -       - http://www.msvmaster.lv

AUG./15/2003

5 1 0 U S A

WARNINGS:

As with any product that performs automatic functions, there are certain safety precautions that you must practice and be

a w a r e o f .

1. Keep the transmitter out of children’s reach.

2. Do not leave anyone in the vehicle while running on remote control.

3. Alert servicing personnel that the vehicle can be started automatically.

4. Do not start the vehicle by remote while it’s in an enclosed area or garage.

5. Always apply the parking brake and lock the vehicle as you exit the vehicle.

6. Should the unit malfunction, disconnect the fuse until the problem is corrected.

7. The use and operations of this system is the sole responsibility of the operator.

8. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.

OPERATION:

A . R E G U L A R T R A N S M I T T E R O P E R A T I O N :

Transmitter Button System Function Remark

Acti vate The R emote Start Press twice within 3 seconds.

Turn Off The Remote Start Press once a nd rel ease

B. TO REMOTE START THE VEHICLE:

When you want to start your vehicle,

1 . P r e s s t h e t r a n s m i t t e r button twice to start the vehicle.

2 . T h e p a r k i n g l i g h t w i l l a c t i v a t e t o i n d i c a t e t h e r e m o t e s t a r t r e c e i v e d t h e s i g n a l .

3 . I t w i l l t a k e a p p r o x i m a t e l y 5 s e c o n d s f o r t h e e n g i n e t o s t a r t .

4 . O n c e t h e e n g i n e i s r u n n i n g , a f t e r c o u p l e s e c o n d s t h e p a r k i n g l i g h t w i l l t u r n o n a g a i n a n d c l i m a t e c o n t r o l s w i l l a c t i v a t e

and adjust the vehicles interior temperature to your preset setting.

5 . T h e v e h i c l e w i l l r u n f o r 5 t o 3 0 m i n u t e c y c l e a n d a u t o m a t i c a l l y s h u t d o w n .

NOTE: The following safety and security conditions exist with this unit.

The Remote Start Unit will not start the vehicle if any one of the following conditions exists:

1 . T h e h o o d i s o p e n e d .

2 . T h e b r a k e p e d a l i s p r e s s e d .

3 . M o v e t h e o p t i o n a l r e m o t e s t a r t e n a b l e t o g g l e s w i t c h t o O F F p o s i t i o n . ( I f i n s t a l l e d )

4 . T h e g e a r s e l e c t o r i s i n a n y g e a r o t h e r t h e n “ P A R K ” o r “ N E U T R A L ”

C. TO TURN OFF THE REMOTE START:

When the engine is running (by remote start), if you want to stop it, you can do one of three things:

1 . P r e s s a n d r e l e a s e t h e t r a n s m i t t e r button.

2 . M o v e t h e o p t i o n a l r e m o t e s t a r t e n a b l e t o g g l e s w i t c h t o O F F p o s i t i o n . ( I f i n s t a l l e d )

3 . P r e s s t h e b r a k e p e d a l

T he v e hi c le w i ll s h ut d o wn a n d t ur n o ff t h e pa r k i n g l i g h t t o i n d i c at e e n g i n e s t o p p ed .

D. TO OPERATE THE VEHICLE WHILE RUNNING ON THE REMOTE START:

To operate the vehicle after you have used the remote start function:

1 . I n s e r t t h e i g n i t i o n k e y a n d t u r n i t t o “ O N ” ( n o t t h e s t a r t ) p o s i t i o n .

2 . P r e s s t h e b r a k e p e d a l .

Note: If the brake pedal is pressed before the key is in the “ON” position, the engine will shut down.

SVMASTER -       - http://www.msvmaster.lv

AUG./15/2003

5 1 0 U S A

E. TEMPORARY STOP FEATURE:

This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for

occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the engine running

and the climate control on.

1.Before turning off the engine, Place the vehicle in “Park”; take your foot off the brake pedal; press the transmitter

button twice and the LED indicator will flash 3 times to confirm enter.

2.Turn the ignition key to the “OFF” position and remove the key. (The engine will stay running.)

3.The engine will run until the pre-programmed tim e has elapsed or one of the shutdown inputs is received.

F. TIMER START:

This unit can be programmed to start and run the engine every 3 hours. The engine will run for the programmed run time

an d then shut down.

IMPORT ANT : Timer Start should be used only in open areas. You should never start and run the vehicle in on enclosed

space as a garage or carport.

3 ho ur s tim er star t: This feature is design for an extreme cold climate usage. The system will auto start the vehicle every

3 hours, to prevent extremely difficult cold start problems. A MAXIMUM OF SIX CYCLES CAN OCCUR.

E N T E R :

1 . P r e s s t h e t r a n s m i t t e r button twice to remote start the vehicle. As soon as the vehicle is running and the parking

l ig ht s h av e t ur n ed o n o r f l as hi ng .

2 . I m m e d i a t e l y d e p r e s s t h e and button together at the same time, within 2 seconds

3 . Q u i c k l y p r e s s t h e button. The parking light will flash (3) times. The horn (if installed) chirps (3) times. The vehicle

is now programmed to start every (3) hours.

4 . P r e s s t h e b r a k e p e d a l t o s t o p t h e v e h i c l e r u n n i n g .

Exit the timer start:

Timer start can be exited manually as follows:

1 . M a k e s u r e t h e r e m o t e s t a r t s y s t e m i s n o t o p e r a t i n g t h e e n g i n e .

2. Turn the ignition “ON”. The LED and parking light will flash (4) times. The horn (if installed) chirps (4) times.

1. Press the transmitter button twice to remote start the vehicle. As soon as the vehicle is running and the

parking lights have turned on or flashing.

2. Immediately depress the a n d button together at the same time; then press and hold butt on for 2

seconds.

The parking lights will flash (4) times. The horn (if installed) will chirp (4) times. The vehicle is no longer programmed to

start automatically.

G. SHUT-DOWN INPUT FOR REMOTE STARTER:

If any of the following conditions exist while the system is operating, the engine will not start or will shut down immediately:

1 . T h e h o o d i s o p e n e d .

2 . T h e b r a k e p e d a l i s p r e s s e d .

3 . M o v e t h e o p t i o n a l r e m o t e s t a r t e n a b l e t o g g l e s w i t c h t o O F F p o s i t i o n . ( I f i n s t a l l e d )

4 . E n g i n e i s o v e r - r e v v e d . { “ T a c h o m e t e r c h e c k i n g t y p e ” o n l y }

5 . T h e p r e - p r o g r a m m e d r u n t i m e ( 5 / 1 0 / 2 0 / 3 0 m i n u t e s ) h a s e l a p s e d .

6 . P r e s s t h e t r a n s m i t t e r b u tt on .

7 . T h e v e h i c l e r e f u s e d t o s t a r t r u n n i n g a f t e r { 3 } u n s u c c e s s f u l a t t e m p t s .

8 . I f y o u r r e m o t e s t a r t d o e s n o t s t a r t t h e v e h i c l e a f t e r 3 a t t e m p t s , p l e a s e t a k e y o u r v e h i c l e b a c k t o y o u r i n s t a l l i n g