AMPLIFICAZIONI
LVR600BP
www.amplificazionilombardi.it
manual
AMPLIFICAZIONI
Potentially dangerous situations can occur and cause
personal injuries.
Potentially dangerous situations can occur and cause
damage to the equipment.
Potentially dangerous situations can occur and cause
the equipment malfunction.
manual references
LVR600BP
www.amplificazionilombardi.it
WARNING !
LVR600BP manual
Version 1.1, 14/04/2017
© by Lombardi Amplificazioni all right reserved.
The data in this manual were precisely controlled, however their accuracy
cannot be guaranteed. Lombardi Amplificazioni takes no responsibility for any
errors or imprecisions in this manual or about the products to which it refers.
As a manufacturer we reserve the right to modify the products under the law
provisions in order to improve the quality.
Amplificazioni Lombardi
via G.Mengozzi 21/b, cap.47011 Castrocaro Terme (FC) ITALY Telephone -
fax +39 0543 767482
E-mail: [email protected]
general information
AMPLIFICAZIONI
Please read the manual carefully and observe the
precautions to prevent and to avoid damages to the
equipment, before using the products of Lombardi
Amplification.
Please keep this manual for future references.
precautions for use
www.amplificazionilombardi.it
WARNING !
information on the usage of the speakers
Do not stand nearby speakers with the volume turned
up. The loudspeakers system can cause a sound
pressure level damaging to health, especially in case of
long lasting exposures. WARNING! The speakers exert
a static magnetic field even when they are connected
or in use. Therefore make sure during assembly and
transport, that they are not nearby things or devices that
can be damaged by an external magnetic field.
Use the proper fasteners and accessorizes (hook, eyelet,
snap-hook, small chains) and follow the instructions to
avoid potential personal injury or property damage.
All the screw, the fasteners and the accessorizes must
be checked periodically.
LVR600BP
AMPLIFICAZIO
rated impedance
maximum power (dB)
power 1W with 1mt (dB)
speakers
dimensions (DxHxW)
weight (kg)
Use
BI AMPLIFIER: 4 Ohm medium /low – 8 Ohm high
139 dB SPL 1mt in free field
HIGH: 8 Ohm: 101,1 dBA – LOW: 4 Ohm: 95,8 dBA
1 coaxial: 1 woofer 250mm 10" ceramic – 1 driver with 1.44" Kapton
membrane
38,7x38,7x32,5 cm
13,6
characteristics
www.amplificazionilombardi.it
cluster loudspeaker
audio and video amplification system
cinema / surround system
amplification front stage/ side / drum files
music for pub / club / squares / theaters of all sizes
nightclub
live music
playback
spoken
LVR600BP
Passive acoustic 2 ways loudspeaker with bass reflex system,
a coaxial speaker, 10" woofer, a metallic horn driver with
compression, 1.44" Kapton membrane and a passive filter
net. It is an high quality and compact product with a good
power for dimensions. It can be piloted both in mono-
amplification and in bi-amplification, there is a rotating
selector in the rear panel that allows to select “mono” or “bi”
amplification. The acoustic loudspeakers Lombardi
LVR600BP can be piloted in mono-amplification with a max
400W RMS on 4 Ohm amplifier, or in bi-amplification with
a max 400W RMS on 4 Ohm amplifier for low-medium
frequencies and max 200W RMS on 8 Ohm amplifier for
high frequencies. The loudspeakers are really compact but have
an high quality and a great power for dimensions. They are perfect
both for fitting on support or modular loudspeaker.
They can create horizontal and vertical cluster that have a coverage of up to 360°
with a vertical angle of 70° (WARNING: use the appropriate structures to hang it).
The loudspeakers componibility allows the realization of polyhedric and semi-spherical
structures.
AMPLIFICAZIONI
frequency response
maximum power
maximum power (dB)
power 1W with 1mt (dB)
speakers
coverage
cut-off frequency
input
output
technical specifications
pagina 5 di 9
www.amplificazionilombardi.it
80 - 20000 Hz
600W RMS / 800W peak
139 dB SPL 1mt in free field
HIGH: 8 Ohm: 101,1 dBA – LOW: 4 Ohm: 95,8
dBA
1 coaxial speaker
high: 1integrated driver with coaxial woofer with
horn, circular radiation 70° and Kaptone membrane
8 Ohm 1.44" – 200W RMS
low: 1 neodymium woofer 4 Ohm – 250mm 10" –
400W RMS
horizontal 90° vertical 70°
3200 Hz 12 dB/oct medium high - (cut-off frequency
recommended 113Hz sub medium high)
female speakon 4 poles for panel
female speakon 4 poles for panel
cabinet
material
finish
descricption
suitable
handles
support feet
outside: poplar plywood 15mm
front panel: lamellar seasoned fir 30mm
inside support: birch plywood
black polyurea coating opaque shock absorbent and
waterproof
metal protection with grille and open cell poliestic
acoustic foam
for cluster installation (with junctions)
hungable with eyelet (16 fitted)
on pedestal
modular on pedestal with double embedding for
sliding bar (up and down)
double front transport handle
feet
LVR600BP
AMPLIFICAZIONI
www.amplificazionilombardi.it
pagina 6 di 9
in the rear panel of the loudspeaker LVR600BP there is
a SPEAKON input and a SPEAKON output bridged
between them.
input and output:
SPEAKON female connector for panel
1 + medium / low frequencies
1 – medium / low frequencies
2 + high frequencies
2 – high frequencies
inputs and connections
LVR600BP
passive
crossover
W
TW
1+
1-
2-
2+
SPEAKON
IN
+
-
+
-
+
-
HF
LF
+
-
HF
LF
1+
1-
2-
2+
SPEAKON
OUT
AMPLIFICAZIONI
cabinet dimension in mm [inch]
www.amplificazionilombardi.it
front panel – speaker section
pagina 7 di 9
side panel
LVR600BP
under panel
up
back
junction
board
junction
stake
385 [15,16]
385 [15,16]
291 [11,46]
385 [15,16]
8°
291 [11,46]
385 [15,16]
8°
291 [11,46]
anchor long board
anchor short board
side view
upper view
385 [15,16]
325 [12,80]
screw-
thread for
the junction
of the
loudspeake
rs
handles
rubber
feet
325 [12,80]
hole for the pole or
the junction of the
loudspeakers
325 [12,80]
385 [15,16]
screw-
thread for
the junction
of the
loudspeake
rs
hole for the pole or
the junction of the
loudspeakers
AMPLIFICAZIONI
accessories to hung it
www.amplificazionilombardi.it
pagina 8 di 9
LVR600BP
hungable: with eyelets and junctions
stative: with central junction
AMPLIFICAZIONI
European Community directives
www.amplificazionilombardi.it
LVR600BP
This device is in conformity with the requirements of the relevant
European Community directives with regard to the European
Electromagnetic Compatibility Directive (EMC) 89/336/EC as
amended by Directives 92/31/EC and 93/68/EC and the Low
Voltage Directive (LVD) 73/23/EC as amended by Directive
93/68/EC.
This device is in conformity with the European directive 2002/95/EC
as amended on the restriction of the use of certain hazardous
substances in electrical and electronic equipment.
Under Directive WEEE 2002/96/EC as amended by Directive
2003/108/EC this device is marked with a crossed-out wheeled
bin, as shown below. “INFORMATION TO USERS: In accordance
with article 13 of the Legislative Decree No 151 of 25 July 2005,
2002/95/EC and 2002/96/EC on the restriction of the use of certain
hazardous substances in electrical and electronic equipment and
of the waste disposal.
The symbol of the crossed-out wheeled bin indicates that the
product at the end of its useful live should be collected separately
from all other waste. The user should bring the end-of-life
equipment to the appropriate waste collection center of electrical
and electronic equipment, or deliver it to the retailer when they
buy a new equivalent equipment, at the ratio of one to one.
Separate collection of waste followed by its proper treatment and
proper waste disposal can greatly improve environmental and
health protection and promote the recovery and recycling of the
materials of the equipment.
Illegal waste dumping shall lead to the application of the
administrative penalties provided for in Legislative Decree No 22
/1997”.
made in Italy
/
