White Mountain Hearth Boulevard Direct-Vent Linear Fireplace DVLL60 Unpacking Instruction Owner's manual

Category
Fireplaces
Type
Owner's manual
36054-3-0618 Page 1
TOOLS REQUIRED:
• Metal Shear - To Cut Band Straps
• 5/16-inch Hex Drive With Extension
UNPACK THE FIREPLACE
1. Cut the binding straps and remove the shrink wrap.
2. Remove the top protective board and corner posts.
3. Inspectthereplaceforshippingdamage.
4. Liftthereplacefromthepallet.
CAUTION
This is an extremely heavy replace and requires two or more
people to move it. Use gloves when moving this replace.
5. Removethenon-combustibleboardsfromthepallet
andsetthemasideforuselater.
NOTICE:
Non-combustibleboardisrequiredfor
installationabovethereplaceasspeciedinthe
installation instructions.
6. Placethereplacenearitsnalinstallationlocation.
7. The Installation Instruction pack is located to one side
ofthereplace.
NOTICE: The burner or burner screen may have some
discolorationfromtestringatthefactory.Thisisnormal
and will not be visible once the burner screen is covered
with decorative crushed glass media.
REMOVE THE BARRIER SCREEN
1. Removethebarrierscreenassemblybygentlylifting
upwardtorelease,thenpullforward.
REMOVE DOOR LIMITER BRACKET
2. Onsomemodels,beforetheGlassDoorcanbe
removed, a Door Limiter Bracket must be removed.
Using a 5/16-inch hex driver with extension, remove (4
or 5) #10-24 x 3/8-inch screws that retain the Limiter
BrackettothebottomangeoftheGlassDoorframe,
and set the bracket aside. See Figure 1.
NOTICE: TheDoorLimiterBracket,ifincluded,
mustbere-installedtotheGlassDoorframepriorto
operationofthereplace.
DOOR LIMITER BRACKET
GLASS DOOR FRAME
Figure 1
REMOVE THE GLASS DOOR
3.
Remove the glass door using the glass door tool
securedtothetopofthereplace.Usingthetoolasa
lever,releasethebottomoftheglassdoorasshown
in Figure 2.
GLASS DOOR REMOV
AL TOOL
PLACE SMALL 90° END OF
THE
GLASS DOOR REMOVAL TOOL
BEHIND THE BOTTOM DOOR
FLANGE, THEN MOVE TOOL
SIDEWAYSTO DISENGAGE
THE RETAINER CLIPS
Figure 2
NOTICE: Tabs at the top allow the glass door to pivot
outwardatthebottom.Springclipsatthebottomofthe
doorframeengagefourbullettyperetainerstosecure.
4. Pivottheglassdooroutwarduntilthebottomofthe
dooropens6to8inches.Liftupwardonthedoorto
disengagethetopfromthetabretainersatthetop.
See Figure 3.
NOTICE: Because the door is extra long and heavy, it is
recommended that two people remove and install the
GlassDoortogether.
PIVOT
OUT
TABS
2
LIFT UP TO
RELEASE OFF
THE TABS
GLASS DOOR
ASSEMBLY
FIREPLACE
FACE
1
Figure 3
IMPORTANT! PLEASE READ!
36054-3-0618Page 2
MOVING FIREPLACE
Ifnecessary,thereplacecanbemovedwithahandtruck
as shown in Figure 4. The valve end must be up.
Beforemovingthereplacewithahandtruck,unpackthe
replace,removethebarrierscreen,glassdoor,inner
packaging materials, and the light cover. (If included)
TRUCK WITH
VALVE END UP
Figure 4
  • Page 1 1
  • Page 2 2

White Mountain Hearth Boulevard Direct-Vent Linear Fireplace DVLL60 Unpacking Instruction Owner's manual

Category
Fireplaces
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI