Installation Guide – DOC. 6504A Adagio: Label Strip • 1
Adagio
®
Label Strip Installation
Congratulations on purchasing your custom-engraved label strip from Crestron
®
. Prior to installing your new
label strip, you must first remove the label strip that is included from the factory. The only tool required is a
small flat-edged screwdriver approximately 1/8” to 1/4" wide (or other flat-bladed tool).
Removing the Old Label Strip
1. Remove the blank label with a small, flat-head screwdriver. The blank label is magnetically attached to
the front panel of the Adagio
®
component. The label strip will be exposed.
2. Insert the screwdriver behind the label strip as shown in the diagram below.
3. Continue sliding the screwdriver behind the label strip until the top of the label strip slides out as shown
below.
4. Continue sliding the screwdriver until the entire top of the label strip is visible. Remove the label strip by
pulling the top of the label strip up from the Adagio component as shown below.
5. Repeat steps 1 through 4 for any other label strips.
Crestron Electronics, Inc. Installation Guide – DOC. 6504A
15 Volvo Drive Rockleigh, NJ 07647 (2015672)
Tel: 888.CRESTRON 06.13
Fax: 201.767.7576 Specifications subject to
www.crestron.com change without notice.
Installing the Engraved Label Cover
1. Place the engraved label over the label area of the Adagio component until the label strip’s integrated
magnets snap the label cover into place.
NOTE: Observe proper orientation so the letters are right-side up.
Further Inquiries
If you cannot locate specific information or have questions after reviewing this sheet, please take advantage
of Crestron's award winning customer service team by calling the Crestron corporate headquarters at
1-888-CRESTRON [1-888-273-7876]. For assistance in your local time zone, refer to the Crestron website
(
www.crestron.com) for a listing of Crestron worldwide offices.
You can also log onto the online help section of the Crestron website to ask questions about Crestron
products. First-time users will need to establish a user account to fully benefit from all available features.
The specific patents that cover Crestron products are listed at
patents.crestron.com.
Crestron, the Crestron logo, and Adagio are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States
and/or other countries. Other trademarks, registered trademarks and trade names may be used in this document to refer to either the
entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others.
Crestron is not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2013 Crestron Electronics, Inc.
-
1
-
2
Crestron AES Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Crestron AES User manual
-
-
-
-
-
-
-
-
-
Other documents
-
Crestron electronic on wall speaker User manual
-
Crestron electronic AudioExpander User manual
-
Crestron electronic Surround Sound Tuning Kit User manual
-
Crestron electronic CEN-UPS1250 User manual
-
Crestron electronic DIN-8SW8 User manual
-
Crestron electronic DIN-1DIMU4 User manual
-
Calculated Industries 6260 User manual
-
ELICA PRF0006191 Datasheet
