Chamberlain CRC1 is a centralising module with a continuous impulse, a 230V control line, a 230V, 50Hz mains voltage and a max. switch output of 5 A. This device can be used for individual operation, and it is recommended to use a larger wire cross-section if more than 4 motors are connected to a line. It is important to note that installation and wiring must be in compliance with your local building and electrical codes, and the power cord should only be connected to properly earthed mains. Before performing any repairs or maintenance on the drive, power must be completely interrupted.
Chamberlain CRC1 is a centralising module with a continuous impulse, a 230V control line, a 230V, 50Hz mains voltage and a max. switch output of 5 A. This device can be used for individual operation, and it is recommended to use a larger wire cross-section if more than 4 motors are connected to a line. It is important to note that installation and wiring must be in compliance with your local building and electrical codes, and the power cord should only be connected to properly earthed mains. Before performing any repairs or maintenance on the drive, power must be completely interrupted.
Chamberlain CRC1 is a centralising module with a continuous impulse, a 230V control line, a 230V, 50Hz mains voltage and a max. switch output of 5 A. This device can be used for individual operation, and it is recommended to use a larger wire cross-section if more than 4 motors are connected to a line. It is important to note that installation and wiring must be in compliance with your local building and electrical codes, and the power cord should only be connected to properly earthed mains. Before performing any repairs or maintenance on the drive, power must be completely interrupted.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI