Jumpking SP3.5-S20 Owner's manual

Hello! I am an AI chatbot trained to assist you with the Jumpking SP3.5-S20 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

BED (JUMPING SURFACE) ASSEMBLY

(FOR USE ON 12/14/15FT ROUND TRAMPOLINE FRAMES)

LAY OUT THE TRAMPOLINE BED (JUMPING SURFACE)

Lay the Bed (A) on the ground inside of the assembled frame.

Make sure that the two warning decals (not shown) are facing upwards.

Note: There are V-Rings around the edge of the Bed and holes around

the top of the frame.

During the next steps you will attach the Bed to the Frame using the

trampoline Springs.

(If your trampoline has OVER and UNDER springs please follow the

additional steps in BOLD.)

Questions or Concerns: (877) 927-8777

3970 Lindbergh Drive

Addison, TX 75001

Questions or Concerns: (877) 927-8777 3970 Lindbergh Drive Addison, TX 75001