Atlas Metal Industries RB-5 Installation guide

Brand: Atlas Metal Industries

Model: RB-5

Type: Installation guide

This manual is also suitable for

RB-4
RBD-5

Subsidiary of Mercury Aircraft, Inc.

1135 N.W. 159th DR., MIAMI, FL 33169

PHONE (305) 625-2451, (800) 762-7565, FAX (305) 623-0475, E-mail:

[email protected]

PARTS LIST REFRIGERATED BASE

RB-4, RB-5 & RBD-5 SERIES

RB-5 SHOWN

ITEM

PART

DESCRIPTION

7008-0 RBD-5 Drawer Gasket (Unit not Shown)

97-105 RB-4 & RB-5 Large Door Gasket

97-107 RB-5 Small Door Gasket

2 S90253-4 Door Assembly RB-4 & RB-5

3 S83951-0 Door Assembly RB-5

6055-1 Slam Action Latch

6052-1 Slam Action Latch W/Lock

5 6053-8 Hinge & Cover

S84051-0 RB-4 Grill

S84050-0 RB-5 Grill

7 113-5 Thermometer

8 2060-1 Condensate Water Evap. (Not Shown)

9 1002-0 Power Cord (Not Shown)

10 2006-4 1/4 H.P. Compressor (Not Shown)

Evaporator Coil RB-5 (Not Shown)

11 2119-0

Evaporator Coil RB-4 (Not Shown)

12 22-1406 Thermostat (Not Shown)

13 2013-0 Fan Motor (Not Shown)

14 2014-5 Fan Blade (Not Shown)

15 S81441-0 Fan Guard (Not Shown)

16 S81419-0 Fan Bracket (Not Shown)

17 1149-0 Wire Harness (Not Shown)

18 S83952-0 Tray Rack (Not Shown)

19 2026-0 0.042 Cap Tube (Not Shown)

20 2025-0 Drier (Not Shown)

SLIDE- IN REFRIGERATED BASE

RB & RBD SERIES

--------------------------------------------------------------------------------------------------------------------------------------------------------------------

MODEL

STORAGE

CAPACITY 12 “ X 20” PANS

CUT-OUT

REQUIRED

RB-4

10 Pans- 1 Door

8 cu. ft.

23 1/2" X 55 1/2"

RB-5

15 Pans- 2 Doors

10 cu. ft.

23 1/2" X 69 1/4"

OPERATION

The unit is ready to operate as soon as it is plugged in and turned on. The thermostat has an off position and

numbers from #1 through #7 (number 7 is the coldest). The unit has been pre-tested and set for proper operation

with the thermostat set for 35˚ to 40˚. Do not block air discharge openings inside the base of the unit. A timer is

installed in the system to shut the compressor off every 4 hours (approximately 15 minutes) to eliminate ice build

up on the evaporator coil.

The unit is supplied with a power cord and NEMA plug. Refer to the data plate located in the compressor

compartment for the amperage and voltage information. Use a licensed electrician when installing power source.

Note: Proper ventilation must be provided in counter.

--------------------------------------------------------------------------------------------------------------------------------------------------------------------

MAINTENANCE

NEVER CLEAN THE UNIT WITH A CHLORIDE BASED PRODUCT. CHLORIDES OR IMPROPER

CLEANING COULD SCAR, MARK AND/OR CORRODE METAL. DO NOT USE STEEL WOOL OR

ABRASIVE PRODUCTS. TO CLEAN USE SOAPY WARM WATER, RINSE THOROUGHLY TO REMOVE

ALL RESIDUES.CLEAN CONDENSER COIL REGULARLY. FAILURE TO MEET THESE

CONDITIONS WILL VOID WARRANTY.