Infiniti T1 TREADMILL, ASPIRE 1680 TREADMILL, QUEST 200 TREADMILL, QUEST 300 TREADMILL, SS1200i SPORT SERIES TREADMILL, SS3000i SPORT SERIES TREADMILL, SS4000i SPORT SERIES TREADMILL, SS800 SPORT SERIES TREADMILL, T2 TREADMILL, T3 TREADMILL Operating instructions

Hello! I am an AI chatbot trained to assist you with the Infiniti T1 TREADMILL Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

TREADMILL RUNNING BELT LUBRICATION

Lubrication of Infiniti treadmills is essential to operation. The treadmill must be lubricated

with 20ml of silicone once every month or every 20 hours of use, whichever comes first.

To lubricate, lift running belt as high as possible about halfway along. Insert straw from

silicone bottle so it reaches to the middle of the belt area. Start pumping whilst withdrawing

straw towards the edge. 25 pumps are required on each side. Repeat procedure on

opposite side. If belt is stuck under side rail, use a screwdriver to lever out. The entire width

must be covered.

ONLY INFINITI SILICONE MAY BE USED. Many market silicones contain petroleum additives

which are destructive. No aftermarket lube kits such as “Lube & Walk” are to be used.

Infiniti silicone may be purchased from your local dealer for Infiniti Fitness. If unsure

about lubrication procedure, contact your local dealer or Infiniti Fitness.

WARNING! Warranty void if treadmills are not

maintained with silicone correctly!

Cover full width.

25 pumps per

side.

Lift belt as

high as

possible