Solo 727 Operating instructions
- Category
- Battery chargers
- Type
- Operating instructions
Solo 727 is a battery charger designed for fast charging of NiMH Battery Batons (Solo 770 only). It features an LED display that indicates the charging status with red/green flashing for testing battery, solid red for fast charging, solid green for trickle charging, and red flashing for faulty battery. The charger automatically switches to trickle charge after fast charging is complete, maintaining the battery in a fully charged state. It has safety features like double insulation and overheat protection, ensuring safe and reliable charging.
Solo 727 is a battery charger designed for fast charging of NiMH Battery Batons (Solo 770 only). It features an LED display that indicates the charging status with red/green flashing for testing battery, solid red for fast charging, solid green for trickle charging, and red flashing for faulty battery. The charger automatically switches to trickle charge after fast charging is complete, maintaining the battery in a fully charged state. It has safety features like double insulation and overheat protection, ensuring safe and reliable charging.
Product Code: Solo 727
• Batteries leave the manufacturer fully charged. Depending on the length of their subsequent storage,
they may require recharging before first use.
• Connect the charger to a 100/240V - 50/60Hz mains socket or to a 12V power socket in a car/van
using the mains lead or the umbilical DC connecting lead supplied.
• For connection to a supply not in the U.S.A., use an attachment plug adapter of the proper
configuration for the power outlet, if needed.
WARNING: Never connect AC and DC power at the same time.
• Connect battery to the charger. The LED will flash from red to green for around 5 minutes whilst the
battery status is checked. The LED will then turn red to indicate fast charging, unless the battery is fully
charged, in which case it may go direct to green (ready for use).
• After fast charging is complete (90 minutes for a fully discharged battery), the charge is automatically
converted into a trickle charge and the LED turns green (ready for use).
• The battery charger and battery can remain connected under a trickle charge for several hours without
damage to the battery. This maintains the battery in a fully charged state, ready for use.
NOTE: If battery is not to be used for sometime (i.e. within the next day), it is advisable to unplug the
charger from the power supply.
• To stop charging disconnect the power plug before removing the battery from the charger.
• As with all rechargeable batteries, after a few hundred cycles of normal use your battery will eventually
reach the end of its useable life and will hold less charge or not charge properly. At this point it is
recommended that replacement battery is purchased.
• Whenever possible, discharge the battery fully before charging - this will ensure the longest possible
battery life.
Equipment protected throughout by double insulation or reinforced insulation (equivalent to
Class ll of IEC 536)
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
DANGER - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
CAREFULLY FOLLOW THESE INSTRUCTIONS.
Note: Identified by
red sleeve on cable
solo
detectortesters
TM
Instructions for
Solo 727 Battery Charger
& Solo 770 Battery Baton
www.solo-tester.com
Note: Identified
by red end cap
Product Code: Solo 727
• Batteries leave the manufacturer fully charged. Depending on the length of their subsequent storage,
they may require recharging before first use.
• Connect the charger to a 100/240V - 50/60Hz mains socket or to a 12V power socket in a car/van
using the mains lead or the umbilical DC connecting lead supplied.
• For connection to a supply not in the U.S.A., use an attachment plug adapter of the proper
configuration for the power outlet, if needed.
WARNING: Never connect AC and DC power at the same time.
• Connect battery to the charger. The LED will flash from red to green for around 5 minutes whilst the
battery status is checked. The LED will then turn red to indicate fast charging, unless the battery is fully
charged, in which case it may go direct to green (ready for use).
• After fast charging is complete (90 minutes for a fully discharged battery), the charge is automatically
converted into a trickle charge and the LED turns green (ready for use).
• The battery charger and battery can remain connected under a trickle charge for several hours without
damage to the battery. This maintains the battery in a fully charged state, ready for use.
NOTE: If battery is not to be used for sometime (i.e. within the next day), it is advisable to unplug the
charger from the power supply.
• To stop charging disconnect the power plug before removing the battery from the charger.
• As with all rechargeable batteries, after a few hundred cycles of normal use your battery will eventually
reach the end of its useable life and will hold less charge or not charge properly. At this point it is
recommended that replacement battery is purchased.
• Whenever possible, discharge the battery fully before charging - this will ensure the longest possible
battery life.
Equipment protected throughout by double insulation or reinforced insulation (equivalent to
Class ll of IEC 536)
IMPORTANT SAFETY INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
DANGER - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK
CAREFULLY FOLLOW THESE INSTRUCTIONS.
Note: Identified by
red sleeve on cable
solo
detectortesters
TM
Instructions for
Solo 727 Battery Charger
& Solo 770 Battery Baton
www.solo-tester.com
Note: Identified
by red end cap
LED DISPLAY
Red/Green Flashing Testing battery (approx. 5 minutes)
Red Fast charging indicator
Green Trickle charging indicator (ready for use)
Red Flashing Faulty battery
CAUTION
Store charger in a dry place (indoor use only when connected to AC mains). Danger of fire and electric
shock! Do not fast-charge a hot battery, allow the battery to cool down naturally before starting a charge
cycle. Allow the charger to cool down for at least 15 minutes after one fast charge. Stop charging if the
battery becomes too hot during charging (>55-60°C). Do not leave unattended whilst charging. Only
clean with a dry cloth. Do not attempt to open the charger. Repair permitted only by authorised dealer.
Batteries and chargers must be stored and used charged in accordance with stated environmental
conditions.
Environment: Operating temperatures: 0°C to 35°C / 32°F to 95°F
Charge temperature: 10°C to 35°C / 50°F to 95°F
Discharge temperature: -10°C to 45°C / 14°F to 113°F
Storage temperature: -25°C to 75°C / -13°F to 167°F
Humidity: 0-90% RH non-condensing
ATTENTION
This charger is designed for charging fast rechargeable NiMH Battery Batons (Solo 770 only).
Do not connect other types of batteries. Danger of explosion.
ENVIRONMENT
Batteries must be disposed of at a recognised recycling centre. Local authorities can provide advice on
the best method.
LI32387-2
LED DISPLAY
Red/Green Flashing Testing battery (approx. 5 minutes)
Red Fast charging indicator
Green Trickle charging indicator (ready for use)
Red Flashing Faulty battery
CAUTION
Store charger in a dry place (indoor use only when connected to AC mains). Danger of fire and electric
shock! Do not fast-charge a hot battery, allow the battery to cool down naturally before starting a charge
cycle. Allow the charger to cool down for at least 15 minutes after one fast charge. Stop charging if the
battery becomes too hot during charging (>55-60°C). Do not leave unattended whilst charging. Only
clean with a dry cloth. Do not attempt to open the charger. Repair permitted only by authorised dealer.
Batteries and chargers must be stored and used charged in accordance with stated environmental
conditions.
Environment: Operating temperatures: 0°C to 35°C / 32°F to 95°F
Charge temperature: 10°C to 35°C / 50°F to 95°F
Discharge temperature: -10°C to 45°C / 14°F to 113°F
Storage temperature: -25°C to 75°C / -13°F to 167°F
Humidity: 0-90% RH non-condensing
ATTENTION
This charger is designed for charging fast rechargeable NiMH Battery Batons (Solo 770 only).
Do not connect other types of batteries. Danger of explosion.
ENVIRONMENT
Batteries must be disposed of at a recognised recycling centre. Local authorities can provide advice on
the best method.
LI32387-2
-
1
-
2
Solo 727 Operating instructions
- Category
- Battery chargers
- Type
- Operating instructions
Solo 727 is a battery charger designed for fast charging of NiMH Battery Batons (Solo 770 only). It features an LED display that indicates the charging status with red/green flashing for testing battery, solid red for fast charging, solid green for trickle charging, and red flashing for faulty battery. The charger automatically switches to trickle charge after fast charging is complete, maintaining the battery in a fully charged state. It has safety features like double insulation and overheat protection, ensuring safe and reliable charging.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
ESP ExB Series Technical And Operating Manual
-
Hypertech EOS0610IDUOII User manual
-
Microchip Technology MCP1630 NiMH User manual
-
Duratrax Onyx 100 Owner's manual
-
Bowens BWL-0440 User manual
-
Zebra Technologies MP User manual
-
Medion AUTO XS MD 18559 User manual
-
-
-
Nilfisk-ALTO SCRUBTEC 795 L User manual
