Hoist Fitness RPL-5305 User manual

Category
Fitness, gymnastics & weight training
Type
User manual
ADDENDUM
RPL-5305 ADDENDUM
EXISTING PAGES IN THE RPL-5305 MANUAL
Fax
(800) 548-5438
(858) 578-7676
(858) 578-9558
Note: Both Serial Number and Model Number are Required when Ordering Parts
RECORD SERIAL NUMBER HERE
Customer Service
READ THIS FIRST!
CATALOG NUMBER 0608-000
THE FOLLOWING PAGES WILL SUPERCEDE THE
OWNER'S MANUAL
RPL-5305
23
21
56
65
FRAME ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE.
OWNER'S MANUAL
RPL-5305 ASSEMBLY
PAGE 20
MACHINE ADJUSTMENT
NOTE:
- SOME PARTS MAY HAVE BEEN
REMOVED FOR CLARITY.
OWNER'S MANUAL
PAGE 27
RPL-5305 ASSEMBLY
135
28
109
STEP 2:
135
51
STEP 1:
MAJOR ADJUSTMENT:
STEP 1:
BE SURE THE BOTTOM DUAL HOLE BUMPER (53) OF THE
LIFT ARM ASSEMBLY REMAINS IN CONTACT WITH THE
BASE FRAME ASSEMBLY (13), AS SHOWN.
STEP 2:
ADJUST HEIGHT OF THE LIMITING STOP ASSEMBLY
(9) SO THAT IT IS IN CONTACT WITH THE DUAL HOLE
BUMPER (53), AS SHOWN. ONCE THE LIMITING STOP
IS PROPERLY ADJUSTED, WRENCH TIGHTEN JAM
NUT (27).
33" [780mm]
28
29
16
MAJOR ADJUSTMENT:
LOOSEN JAM NUTS (28, 29) AND TWIST TIE RODS (16)
IN/OUT TO ADJUST THE PRESS ARMS TO THE PROPER
HEIGHT. ONCE THE PROPER HEIGHT IS REACHED AND
THE PRESS ARMS ARE OF EQUAL HEIGHTS, BE SURE
TO RE-TIGHTEN JAM NUTS.
MACHINE ADJUSTMENT CONTINUED
OWNER'S MANUAL
RPL-5305 ASSEMBLY
PAGE 28
PART LIST
NOTE: SOME OF THESE PARTS MAY COME PRE-INSTALLED
OWNER'S MANUAL
PAGE 33
ITEM NO. PART NUMBER DESCRIPTION QTY
1 026-01PL2236 TOP CAP W/INSERTS 1
2 026-01X3294 REAR UPRIGHT LEFT ASSEMBLY 1
3 026-01X3377 REAR UPRIGHT RIGHT ASSEMBLY 1
4 026-01X2402 FOOT PLATE ASSEMBLY 2
5 026-01X2849 RACHET PULL-PIN ASSEMBLY 1
6 026-01X2975 FOOT PLATE MOUNT ASSEMBLY 2
7 026-01X3235 CENTER UPRIGHT 1
8 026-01X3287 SHAFT, LIFT-ARM ASSEMBLY 1
9 026-01X3292 LIMITING STOP ASSEMBLY 1
10 026-01X3305 WEIGHT HORN ASSEMBLY 2
11 026-01X3308 LINK ASSEMBLY 2
12 026-01X3404 LIFT ARM DECLINE 1
13 026-01X3409 BASE FRAME ASSEMBLY 1
14 026-01X3411 PRESS ARM RIGHT 1
15 026-01X3412 PRESS ARM LEFT 1
16 026-01X3413 PRESS ARM LINKS 2
17 026-01X3414 LINK MOUNT - LEFT 1
18 026-01X3416 TIE-ROD END LEFT HANDED 2
19 026-01X3417 LINK MOUNT - RIGHT 1
20 026-01X3420 TIE-ROD END RIGHT HANDED 2
21 026-01X2387 SEAT PAD ASSEMBLY 1
22 026-01X3429 USER SUPPORT FRAME ASSEMBLY 1
23 022-01PD2054-A SEAT PAD ASSEMBLY 1
24 022-01PD2055 UPHOLSTERED HEAD PAD 1
25 022-01PD2058 UPHOLSTERED BACK PAD 1
26 011-0111008 SET SCREW: 1/4"-28 X .25" LG. (WZ) 4
27 012-0202001 1/2"-13 FLANGED NUT (WZ) 1
28 012-0105009 12 mm JAMNUT RH 2
29 012-0105010 12 mm JAMNUT LH 2
30 014-0019005-2 SPLIT COLLAR: 1.00" I.D. X 20mmT NON-THREADED 1
31 014-0009007 BEARING: FLANGED Ø2.00" O.D. X Ø1.00" I.D. 4
32 014-0005001 BEARING: (SMALL) Ø1 3/8"" O.D. X Ø3/4"" I.D. 4
33 014-0012013 BEARING: BALL BEARING Ø2.44" O.D. X Ø1.18" I.D. 4
34 016-0001003 END CAP 1.50" X 2.50" (BLACK) 1
35 022-01PD2058-5 PLASTIC BACK PAD BACKING 1
CATALOG NUMBER
OWNER'S MANUAL
RECORD SERIAL NUMBER HERE
Fax
(800) 548-5438
(858) 578-7676
(858) 578-9558
Note: Both Serial Number and Model Number are Required when Ordering Parts
Customer Service
0608 - 001
PLATE-LOADED DECLINE CHEST PRESS
RPL-5305
**WARNING !**
TO PREVENT POSSIBLE TIPPING, BOLT THIS UNIT TO THE
EXERCISE FLOOR. FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY OR DEATH.
OWNER'S MANUAL
PAGE 01
RPL-5305 ASSEMBLY
INSTRUCTIONS .....................................................................
FRAME ASSEMBLY ..............................................................
MACHINE ADJUSTMENT .....................................................
PRE-ASSEMBLY....................................................................
DECAL PLACEMENT.............................................................
DECAL REFERENCE.............................................................
PART LIST...............................................................................
ABBREVIATIONS...................................................................
BOLT SIZING CHART............................................................
WASHER SIZING CHART......................................................
MAINTENANCE SCHEDULE.................................................
GENERAL MAINTENANCE INFORMATION........................
WEIGHT TRAINING TIPS.......................................................
EXERCISE LOG......................................................................
LIMITED WARRANTY............................................................
CONTENTS
02
04
27
29
30
31
33
36
37
39
41
42
43
44
45
OWNER'S MANUAL
PAGE 02
RPL-5305 ASSEMBLY
Ratchet Wrench
1/2", 9/16" and 3/4" Sockets
Adjustable Wrench
Rubber Mallet
Tape Measure
Level
Hex Key Wrench Set
Two People
TOOLS REQUIRED
Before beginning assembly please take the time to read instructions
thoroughly. Please use the various lists in this manual to make sure that
all parts have been included in your shipment. When ordering, use part
number and description from the lists. Use only HOIST replacement parts
when servicing. Failure to do so will void your warranty and could result
in personal injury.
HOIST equipment is designed to provide the smoothest, most effective
exercise motion possible. After assembly, you should check all functions to
ensure correct operation. If you experience problems, first recheck the
assembly instructions to locate any possible errors made during assembly.
If you are unable to correct the problem, call your authorized HOIST dealer.
Be sure to have your serial number and this manual when calling. When all
parts have been accounted for, continue on.
INSTRUCTIONS
OWNER'S MANUAL
PAGE 03
RPL-5305 ASSEMBLY
***THIS PAGE WAS INTENTIONALLY LEFT BLANK***
OWNER'S MANUAL
PAGE 04
RPL-5305 ASSEMBLY
FRAME ASSEMBLY
OWNER'S MANUAL
PAGE 05
- HAND TIGHTEN HARDWARE.
- REPEAT ASSEMBLY FOR OPPOSITE SIDE.
RPL-5305 ASSEMBLY
NOTE:
FRAME ASSEMBLY
9
13
73
58
51
58
81
3
2
27
50
10
49
10
57
61
69
69
61
57
12
49
OWNER'S MANUAL
- WRENCH TIGHTEN HARDWARE.
RPL-5305 ASSEMBLY
PAGE 06
NOTE:
FRAME ASSEMBLY
OWNER'S MANUAL
PAGE 07
RPL-5305 ASSEMBLY
- WRENCH TIGHTEN HARDWARE.
NOTE:
FRAME ASSEMBLY
13
72
57
8
57
80
30
62
12
RPL-5305 ASSEMBLY
- WRENCH TIGHTEN HARDWARE.
PAGE 08
OWNER'S MANUAL
NOTE:
FRAME ASSEMBLY
58
74
81
58
17
19
58
81
12
74
58
PAGE 09
REMOVED FOR CLARITY.
- REPEAT ASSEMBLY FOR OPPOSITE SIDE.
OWNER'S MANUAL
RPL-5305 ASSEMBLY
NOTE:
- WRENCH TIGHTEN HARDWARE.
- SOME PARTS MAY HAVE BEEN
FRAME ASSEMBLY
17
58
81
75
58
12
19
OWNER'S MANUAL
FRAME ASSEMBLY
- HAND TIGHTEN HARDWARE.
RPL-5305 ASSEMBLY
NOTE:
PAGE 10
81
76
58
7
58
81
39
58
13
58
76
2
3
PAGE 11
OWNER'S MANUAL
RPL-5305 ASSEMBLY
- HAND TIGHTEN HARDWARE.
NOTE:
FRAME ASSEMBLY
58
58
78
81
7
3
58
81
37
58
75
2
- WRENCH TIGHTEN ALL PREVIOUSLY
- WRENCH TIGHTEN HARDWARE.
NOTE:
RPL-5305 ASSEMBLY
PAGE 12
OWNER'S MANUAL
HAND TIGHTEN HARDWARE.
FRAME ASSEMBLY
57
67
57
80
80
80
57
57
4
6
67
22
67
57
57
PAGE 13
RPL-5305 ASSEMBLY
NOTE:
- REPEAT ASSEMBLY FOR OPPOSITE SIDE.
FRAME ASSEMBLY
OWNER'S MANUAL
- WRENCH TIGHTEN HARDWARE.
PAGE 14
FRAME ASSEMBLY
RPL-5305 ASSEMBLY
- WRENCH TIGHTEN HARDWARE.
NOTE:
OWNER'S MANUAL
79
58
58
40
22
13
81
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51

Hoist Fitness RPL-5305 User manual

Category
Fitness, gymnastics & weight training
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI