2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Chief
  6. PSB2058

Chief PSB2058 Installation guide

  • Hello! I have analyzed the Installation Instructions for the Chief PSB-2058 Display Mounting Bracket. This document provides detailed steps on mounting your display, including securing the mounting buttons and placing the offset and interface brackets. It emphasizes the importance of structural support capable of handling four times the weight of the equipment. I'm ready to answer any questions you may have about the installation process or specifications.
  • What is the maximum weight supported by the bracket?
    What should I do if I'm missing components?
    Are displays fragile?
    What kind of screws are used for mounting the buttons?
INSTALLATION INSTRUCTIONS
CHIEF MANUFACTURING INC.
1-800-582-6480 952-894-6280 FAX 952-894-6918
8401 EAGLE CREEK PKWY, STE. 700
SAVAGE, MINNESOTA 55378 USA
8804-000312 Rev01
2006 Chief Manufacturing
www.chiefmfg.com
03/06
ALL COMPONENTS MUST BE SECURELY FASTENED TO A
STRUCTURAL MEMBER CAPABLE OF SUPPORTING 4
TIMES THE COMBINED WEIGHT OF ALL COMPONENTS
PLUS THE EQUIPMENT BEING MOUNTED. IF IT CANNOT
SUPPORT THIS WEIGHT, THE STRUCTURE MUST BE
REINFORCED.
THE MAXIMUM WEIGHT TO BE INSTALLED ON THE
BRACKET IS 175 POUNDS
(
79.38 KG
)
.
PSB-2058
DISPLAY MOUNTING BRACKET
Prior to assembly, unpack carton completely and verify contents.
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
(1) Left Interface Bracket (1) Right Interface Bracket
(2) Offset Bracket (4) Mounting Buttons – Tapped 10-24
(8) 10-24 x .5” Phillips Head Cap Screws (4) M4 x 16mm Button Head Cap Screws
(1) M2.5 Allen Key (4) .750 x .323 x .125 Nylon Spacers
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
DISPLAYS ARE EXTREMELY FRAGILE.
1. Using a 10-24 Phillips head cap screw inserted into square holes from back side of bracket, secure mounting
button, with chamfered hole of mounting button (larger surface) facing bracket, to bracket (four places) (see
Figure 2 & Figure 3). Make sure bends of interface bracket face away from buttons.
CAUTION!
Figure 1
WARNING!
Figure 2 Figure 3
2. Place Offset Bracket on mounting holes, aligning square hole pattern on brackets with pattern on back of
display (see Figure 4 & Figure 5).
3. Using M4 button head screws and nylon spacers, secure brackets to display. Do not over tighten screws.
4. Place Interface Brackets on Offset Brackets, aligning hole pattern on Interface with pattern on Offset bracket.
5. Using 10-24 Phillips head cap screws, secure brackets (See Figure 6 & Figure 7). Do not over tighten screws.
6. With the aid of another person, lift display up to Chief Mount, aligning buttons of mounting brackets with
slots in Chief Mount.
7. Lower safety latch on the Chief Mount to secure display, making sure latch is completely engaged.
Figure 4 Figure 5
Figure 6 Figure 7
/