Leckey BeMe Manual Wheelchair Interface Operating instructions

  • Hello! I've reviewed the user manual for LECKEY Wheelchair Interface models 150-1760, 150-2760 and 150-3760. This document provides detailed instructions on setting up the interface, including distance measurements and secure attachment. I am ready to answer your questions about this product and its setup process.
  • What is the recommended distance (X) from the front of the hangar tube to the first collar for a BeMe Zippie Iris in a small setup?
    What is the distance between collars (Y) for the BeMe Quickie SR45 in a medium setup?
    How many pins are required to secure the interface?
    What tool is required to tighten the collar bolts and adjuster screws?
(Y) Is The Distance
Between Collars.
Distance (X) Is A Recommended
Position From Front Of Hangar Tube
To Front Of The First Collar.
Work Instruction Ref: LWI-150-048
Assy Dwg : 150-1760,150-2760, 150-3760 Issue: 001
Customer WI Interface
S1, S2 & S3 set up
(150-1760, 150-2760, 150-3760)
INTERFACE SET UP SMALL
(150-1760)
MEDIUM
(150-2760)
LARGE
(150-3760)
SEAT BASE DISTANCE (X)
BeMe Zippie Iris 75mm
BeMe Zippie Iris 150mm
BeMe Quickie Iris 150mm
BeMe Quickie Iris 150mm
BeMe Quickie Iris 150mm
BeMe Quickie SR45 80mm
BeMe Quickie SR45 80mm
BeMe Quickie SR45 80mm
INTERFACE SET UP SMALL
(150-1760)
MEDIUM
(150-2760)
LARGE
(150-3760)
SEAT BASE DISTANCE (X)
BeMe Zippie Iris 120mm
BeMe Zippie Iris 165mm
BeMe Quickie Iris 120mm
BeMe Quickie Iris 165mm
BeMe Quickie Iris 210mm
BeMe Quickie SR45 120mm
BeMe Quickie SR45 165mm
BeMe Quickie SR45 210mm
STEP 1: Set distance/Attach collars
Remove bolts (x2per) from the collar (x4).
Split collar
Measure distance as stated on Page 1.
(Mark position on base if desired)
Place collar halves on either side of the leg.
Replace bolts loosely.
Work Instruction Ref: LWI-150-048
Assy Dwg : 150-1760,150-2760, 150-3760 Issue: 001
Collar
STEP 2: Attach interface
Unscrew adjuster screws so adjusters can
move in and out of the Interface frame freely.
Slide adjuster out to suit position of collars.
Place interface over all collars.
Adjuster
Adjuster
Screws
Interface
frame
Work Instruction Ref: LWI-150-048
Assy Dwg : 150-1760,150-2760, 150-3760 Issue: 001
STEP 3: Secure Interface
Place pins (x8) through the holes in adjusters
and collar to secure frame.
Pins are all inserted from the front of the
base. (see below)
Secure collar bolts in the following order;
1. Make sure bolts face outward (see
below)
2. Tighten top bolt until hand tight
3. Repeat for bottom bolt
4. Tighten top bolt with 5mm Allen key until
secure
5. Repeat for bottom bolt
Tighten adjuster screws using 5mm Allen key
until tight.
Ensure screws are tight and that the
wheelchair is stable in use once the
user has been seated.
Collar
/