10 49-2001192 Rev. 0
Settings
USING YOUR APPLIANCE: Settings
There are several settings on your range. To access and change these settings, press the Bake and Broil pads at the
same time and hold for three seconds, a beep sounds, then release the buttons and "OFSt" should appear in the display.
Scroll through the Settings menu using the 2 number pad for up and the 8 number pad for down until the desired
feature is displayed. To select a feature to change, or to confirm a change, press the 6 number pad. To cancel a
change and return to the Settings menu, press the 4 number pad. To exit the Settings menu, press Cancel again.
Adjust the Oven Temperature (OFSt)
This feature allows the oven baking temperature to be
DGMXVWHGXSWR)KRWWHURUGRZQWR)FRROHU8VH
this feature if you believe your oven temperature is
running too hot or too cold and wish to change it.
To adjust the oven temperature, enter the Settings menu
as listed above, then scroll through the features until
“OFSt” is displayed and press Start. A number between
DQGZLOOEHGLVSOD\HG8VHWKH2 number pad to
increase the adjusted temperature or use the 8 number
pad to decrease the adjusted temperature. Press 6 to
save the temperature adjustment. Press Cancel to exit
WKH6HWWLQJVPHQX7KLVDGMXVWPHQWZLOODIIHFW%DNH
&RQYHFWLRQ%DNHDQG&RQYHFWLRQ5RDVW
Do not use thermometers, such as those found in
grocery stores, to check the temperature inside your
oven. These thermometers may vary 20-40 degrees.
Sabbath Warmer Setting (Sabb)
This feature allows the user to increase the Sabbath
Warm temperature if the oven is operating cooler
than desired. To adjust this feature Lo or Hi, enter the
Settings menu as outlined above and scroll through the
options until "Sabb" is displayed, then press 6. Scroll to
the desired option and press 6 again to confirm. Press
Cancel to exit the Settings menu.
Sound Volume (Snd)
This feature allows the oven tone volume to be adjusted
On and Off (OFF). To adjust the tone volume, enter the
Settings menu as outlined above and scroll through the
options until “Snd” is displayed, then press 6. Scroll to
the desired option and press 6 again to confirm it. Press
Cancel to exit the Settings menu.
End of Timer Signals (End tonE)
This is the tone that signals the end of a timer. The tone
can be continuous (Cont) or one repeating beep (bEEP).
A continuous setting will continue to sound a tone until
a pad on the control is pressed. A single setting (bEEp)
will sound just a single tone at the end of the timer. To
change the tone, enter the Settings menu as outlined
above and scroll through the options until “End tonE”
is displayed, then press 6. Scroll to the desired option
and press 6 again to confirm it. Press Cancel to exit the
Settings menu.
12-hr Auto Shut Off (12h Shut)
This feature turns off the oven after 12 hours of
continuous operation. To enable or disable this feature,
enter the Settings menu as listed above and scroll
through the options until “12h Shut” is displayed, then
press 6. Scroll to the desired option and press 6 again to
confirm it. Press Cancel to exit the Settings menu.
Fahrenheit / Celsius (dEg Unit)
The oven control is set to use Fahrenheit temperatures
(F), but you can change it to use Celsius temperatures
(C). To toggle between temperature measurements,
enter the Settings menu as listed above and scroll
through the options until “dEg Unit” is displayed, then
press 6. Scroll to the desired option and press 6 again to
confirm it. Press Cancel to exit the Settings menu.
Clock Display (CLoc diSP)
This feature specifies whether the clock appears in the
display. The clock display may be "On" or "OFF." To
change the display, enter the Settings menu as listed
above and scroll through the options until “CLoc diSP”
is displayed, then press 6. Scroll to the desired option
and press 6 again to confirm it. Press Cancel to exit the
Settings menu.
Clock Configuration (CLoc cFg)
This feature specifies how the time of day will be
displayed. You can select a standard 12-hour clock (12) or
24-hour military time display. To change the configuration,
enter the Settings menu as outlined above and scroll
through the options until “CLoc cFg” is displayed, then
press 6. Scroll to the desired option and press 6 again to
confirm it. Press Cancel to exit the Settings menu.
Auto Recipe Conversion (Auto Con)
This feature automatically adjusts traditional baking
WHPSHUDWXUHVIRU&RQYHFWLRQ%DNH0XOWL5DFNFRRNLQJ
To turn this feature "On" or “oFF,” enter the Settings
menu as outlined above and scroll through the options
until “Auto Con” is displayed, then press 6. Scroll to
the desired option and press 6 again to confirm it. Press
Cancel to exit the Settings menu.
Remote Enable (APP EnbL)
Allows you to control your oven remotely. This feature
may be “on” or “oFF.” To change the configuration, enter
the Settings menu as outlined above and scroll through
the options until “APP EnbL” is displayed, then press 6.
Scroll to the desired option and press 6 again to confirm
it. Press Cancel to exit the Settings menu.