Fujitsu STYLISTIC 3400 Installation guide

Fujitsu
Brand
Fujitsu
Model
STYLISTIC 3400
Category
Car kits
Type
Installation guide
Symbol
®
, Proxim
TM
, BreezeCom
TM
, and AiroNet
TM
are trademarks or registered trademarks of their respective companies.
Stylistic 3400 is a trademark of Fujitsu PC Corporation. © 2000 Fujitsu PC Corporation
3/00 58-0715-00A
FUJITSU PC CORPORATION
FMW42RC1
Radio Antenna Cover Kit
Installation Guide
Stylistic 3400
These instructions provide details on assembling
and installing the Radio Antenna Cover Kit for the
Stylistic 3400 pen tablet.
The antenna cover should be installed when most
types of antennae protrude from a radio PC Card.
The cover provides a rigid cap over the antenna to
prevent damage during everyday use.
Assembling the Radio Antenna Cover Kit 0
The Radio Antenna Cover Kit consists of the
following parts:
•Plastic Hood
• Plastic Base
•Two black screws
• One tapping screw
To assemble the radio antenna cover, place the
hood atop the base as illustrated in Figure 1. Make
sure the positioning tab is on the inside of the
hood. Secure the two pieces with the tapping
screw by inserting it through the hole in the base
into the standoff inside the hood.
Installing the Radio Antenna Cover 0
To attach the radio antenna cover to the pen tablet,
perform the following steps.
1. Position the antenna cover in relation to the
back of the pen tablet as shown in Figure 2.
2. If caps are present over the mounting holes,
remove them with a small screwdriver, or
similar tool.
Note
The antenna cover was specifically tested with Symbol
®
,
Proxim
TM
, BreezeCom
TM
, and AiroNet
TM
radios; it is
possible that certain other antennae will protrude too far
from the system to fit within the antenna cover.
3. Insert the antenna cover tabs into the two tab slots
on the pen tablet.
4. Insert the two black screws through the holes in the
hood and secure them to the pen tablet.
Figure 1. Assembling the Radio Antenna Cover
Figure 2. Installing the Radio Antenna Cover
Base
Hood
Tapping Screw
Standoff
Positioning
Tab (inside)
PC Card
Tab
Tab Slots
Mounting
Hole
Slot
  • Page 1 1

Fujitsu STYLISTIC 3400 Installation guide

Fujitsu
Brand
Fujitsu
Model
STYLISTIC 3400
Category
Car kits
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents