Anvil Basket Catch for the Anvil Foundry Owner's manual

Basket Catch Adapter

NOT COMPATIBLE WITH 6.5 GALLON BASKET

Mark mounting hole locations onto the basket by placing the new feet on the right side of

2 adjacent feet on the foundry and using them as a template as shown in Figure 1. Locate

them so the resting surface of the new brackets will sit slightly below the old side feet.

Pay attention to correctly locating the new feet by referencing the picture of the complete

installation at the end of these instructions. Installing these too low will make the basket

incompatible with the small batch adapter ring.

After marking the locations, use a punch and hammer to place a dimple on each hole

location as shown in Figure 2. This step is important to provide accuracy when drilling.

Using a drill and a 5/32 size drill bit drill the holes out as shown in Figure 3. If no 5/32

Drill bit is available, producing any size hole ranging from .150 (5/32) to .172 (11/64)

will be acceptable.

Clean up and remove any hanging burrs on the inside of the basket.

Mount by using a bolt through the new foot and basket, secured with a washer and nut on

the inside of the basket.

The final installation should look like the picture in Figure 3.

This will now hang on the kettle wall. Discard the basket support ring before use.

Figure 1

Figure 2 Figure 3 Figure 4